2. Jabra
  3. PanaCast 50 Video Bar System ZR

Jabra PanaCast 50 Video Bar System ZR, PanaCast 50 Video Bar System, PanaCast 50 Video Bar System MS, PanaCast 50 Video Bar System UC Assembly Instructions

  • I've reviewed the PanaCast 50 Wall Mount user manual. This document provides step-by-step instructions for mounting the PanaCast 50 video bar, either above or below a screen. It details the necessary tools, items included, and how to secure the device correctly. I can help you with any questions you may have about the installation process or the device itself.
  • What items are included in the pack?
    What tools are needed for installation?
    Are screws needed to attach the video bar to the mount?
    How do I access the ports?
Install below screen
Install above screen
PanaCast 50 Video Bar System
Start from page 1
Start from page 5
Wall Mount
Wall Mount
Drill
Items included
Tools needed (not supplied in the pack)
Wall screws
Level
1
8 cm
Measure 8cm from the bottom of the screen to
the top of the Wall Mount. Using a pencil, mark
the screw holes on the wall, as illustrated.
1
Screw the Wall Mount to the wall using a drill
(screws not supplied).
2
2
3Attach the video bar to the Wall Mount. Screws
are not required.
Rotate the video bar down for easy access to
the ports.
4
3
Attach the relevant cables to the video bar..
5
HDMI IN HDMI OUT2 HDMI OUT1 USB-A
USB-C
ETHERNET
POWER
3.5MM JACK
USB-A
Screw the cable cover to the video bar using the
supplied screws.
6
4
Rotate the PanaCast 50 into its final position and
angle the camera to point at eye-level.
7
5
Measure 8cm from the top of the screen to the
bottom of the Wall Mount. Using a pencil, mark
the screw holes on the wall, as illustrated.
8 cm
Screw the Wall Mount to the wall using a drill
(screws not supplied).
1
2
6
3Attach the video bar to the Wall Mount. Screws
are not required.
Rotate the video bar down for easy access to
the ports.
4
7
HDMI IN HDMI OUT2 HDMI OUT1 USB-A
USB-C
ETHERNET
POWER
3.5MM JACK
USB-A
Attach the relevant cables to the video bar..
5
Screw the cable cover to the video bar using the
supplied screws.
6
8
Rotate the PanaCast 50 into its final position and
angle the camera to point at eye-level.
7
/