Jabra PanaCast 50 Video Bar System UC Assembly Instructions

Brand: Jabra

Model: PanaCast 50 Video Bar System UC

Type: Assembly Instructions

This manual is also suitable for

Install below screen

Install above screen

PanaCast 50 Video Bar System

Start from page 1

Start from page 5

Wall Mount

Wall Mount

Drill

Items included

Tools needed (not supplied in the pack)

Wall screws

Level

1

8 cm

Measure 8cm from the bottom of the screen to

the top of the Wall Mount. Using a pencil, mark

the screw holes on the wall, as illustrated.

1

Screw the Wall Mount to the wall using a drill

(screws not supplied).

2

2

3Attach the video bar to the Wall Mount. Screws

are not required.

Rotate the video bar down for easy access to

the ports.

4

3

Attach the relevant cables to the video bar..

5

HDMI IN HDMI OUT2 HDMI OUT1 USB-A

USB-C

ETHERNET

POWER

3.5MM JACK

USB-A

Screw the cable cover to the video bar using the

supplied screws.

6

4

Rotate the PanaCast 50 into its ﬁnal position and

angle the camera to point at eye-level.

7

5

Measure 8cm from the top of the screen to the

bottom of the Wall Mount. Using a pencil, mark

the screw holes on the wall, as illustrated.

8 cm

Screw the Wall Mount to the wall using a drill

(screws not supplied).

1

2

6

3Attach the video bar to the Wall Mount. Screws

are not required.

Rotate the video bar down for easy access to

the ports.

4

7

HDMI IN HDMI OUT2 HDMI OUT1 USB-A

USB-C

ETHERNET

POWER

3.5MM JACK

USB-A

Attach the relevant cables to the video bar..

5

Screw the cable cover to the video bar using the

supplied screws.

6

8

Rotate the PanaCast 50 into its ﬁnal position and

angle the camera to point at eye-level.

7

1
2
3
4
5
6
7
8
9
10

Jabra PanaCast 50 Video Bar System UC Assembly Instructions

Brand: Jabra

Model: PanaCast 50 Video Bar System UC

Type: Assembly Instructions

This manual is also suitable for

Download PDF

Related papers

Other documents