Halcyon EX912 B34, EX912 B34 2.5W Low Glare Wall Eyelid Select Luminaire User manual

  • Hello! I've reviewed the user manual for the HALCYON EX912 B34 Luminaire. The document provides detailed instructions for safe installation, including the need for a qualified electrician, the importance of sealing against water ingress, and specific requirements for cable type. I'm ready to answer any questions you might have about this device.
  • Can I replace the light source?
    What should I do to prevent water ingress?
    What type of cable is necessary?
EX912 B34
FIG-1
FIG-5 FIG-6
1
OFF
ON 2
1
OFF
ON 2
FIG-2
FIG-4
for cable/pipe mm: ∅5-10
H05RN-F 3×1.0mm²
Note: In order to reach the required IP, the
input cable for the luminaries must be
H05RN-F 3×1.0mm², and threading through
before stripping.
1
2
green/yellow
brown
blue
L
N
NL
0.5-2.5mm² with
release facility
please note that the electric
cable opening should come
through the top of the fixture.
1
2
3
2
1
Before installing front face,
please make sure the earth
wire is placed between the
driver and terminal block.
green/yellow
FIG-3-A
Concrete
29MM
3
84MM
Note: Please keep the cable outlet
in the same vertical direction with
the inlet to luminaries
1
2
Wood board
Please make sure the
thickness of the wood
board no less than 10mm
FIG-3-B
21
If the external flexible cable or cord of this luminaire is damaged, it shall
be exclusively replaced by the manufacturer or his service agent or a
similar qualified person in order to avoid a hazard.
The light source of this luminaire is not replaceable;
when the light source reaches its end of life the whole luminaire shall
be replaced.
This luminaire must be installed by a qualified Registered Electrician to
prevent damage to the luminaire and maintain electrical safety.
Base plate,cable entry gland and screw heads must be covered in silicon
sealant. Failure to do so may cause luminaire failure from water ingress.
VER:1.0
4000K
3000K
Attention:
when switching the color
temperature, please make
sure the power is off.
All exterior luminaires (with the exception of copper) require periodic
cleaning to protect the surface and/or coating from corrosion and ensure
tidy appearance for the lifespan of the product. Wash with care using a
soft brush and warm soapy water using a neutral detergent. Coastal
areas require extra attention, especially fittings which are under
eaves/soffits and do not have any exposure to rain. Do not use a water
blaster or high pressure hose, do not submerge fittings for extended
periods of time. 316 stainless steel fittings will still develop surface
rust or “tea staining” if left uncared for.
/