2. BLOTZ
  3. B20_RU_012

BLOTZ B20_RU_012, B20-RU-012 Assembly Instructions

  • I have reviewed the instructions for the BLOTZ 20mm Celtic Archway model. The document includes detailed steps on how to assemble this model with materials like glue and modeling knife and finish it using the paint. I'm ready to answer any questions you may have about its construction or painting.
  • What kind of glue is needed?
    What tool is needed to remove parts from the sprue?
    What kind of paint is recommended?
20mm Ruins #12 – Celtic Archway
B20-RU-012
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the front wall section, side wall and base from
the sprue as shown above.
Glue the side wall to the main wall, then glue both
to the base.
Take the rear wall and other piece of side wall.
Glue them into position.
The archway pieces.
Glue them into place.
The finished model
Once constructed, we sprayed our model with a matt black car undercoat aerosol, then applied a heavy
drybrush of a dark blue/grey colour emulsion.
After that had dried we applied a lighter drybrush of a pale grey colour, then followed this by a very light dry-
brush of an almost white emulsion.
All our emulsion paints are DIY store colour-test pots.
/