2. BLOTZ
  3. BH0-ME-112

BLOTZ BH0-ME-112 Assembly Instructions

  • Hello, I'm a chat assistant and I have analysed the instructions for the BLOTZ Short Wall - Gate model. This manual will guide you through the assembly process, from removing the pieces from the sprue to constructing the desert fort model. I understand the manual thoroughly and am ready to assist you with your questions about the device.
  • What type of glue is required?
    What tool is needed to remove parts from the sprue?
    What can be used to clean joints?
H0mm Desert Fort – Short Wall - Gate
BH0-ME-112
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Attach them together as shown above.
Take the walkway and gates.
Position the walkway and just before you push it
fully down, insert the gates so they lock into the
holes provided.
Add the front wall.
Take these two pieces.
Add the two steps above the entrance.
The finished model.
/