2. FLEXCO
  3. Aero 325 End Belt Clamp Kit

FLEXCO Aero 325 End Belt Clamp Kit Operating instructions

  • Hello! I've reviewed the instructions for the Flexco Aero 325 Splice Press and its End Belt Clamp Kit. This document outlines how to retrofit the press for end-to-end or traditional belt splicing. The instructions provide details on hardware included and the step-by-step process using a 5mm hex wrench. I'm ready to assist with any questions you have about the installation or the device described in the document.
  • What are the two directions for narrow belt splicing with this device?
    What should I use if splicing in the traditional direction?
    What should I use when splicing end-to-end?
    What does the End Belt Clamp Kit include?
Aero® 325 Splice Press
End Belt Clamp Instructions
General Information
Narrow belt splicing will be completed end-to-end (across the length of the press) or in the traditional direction (across the width of the press).
e belt template orientation is determined by nger geometry and belt type.
ere are two versions of the Aero Splice Press for this type of splicing:
If splicing in the traditional direction use 09552 AERO-325.
When splicing end-to-end use 09600 AERO-325-END-BELT-CLAMP.
End belt clamps may be retrotted to 09552 by ordering 09592 AERO-325-END-BELT-CLAMP-KIT
Retrotting 09592 End Belt Clamp Kit to 09552 Aero® 325 Splice Press
End Belt Clamp Kit includes:
Two (2) end clamp assemblies
Four (4) long bolts
Four (4) spacers
Step 1. On bottom press beam end
plate with a 5mm hex wrench, remove
the top bolt on both sides and discard.
Step 2. From End Belt Clamp Kit,
install two long bolts into one end
clamp assembly. e bolt head will
seat in the countersunk indentation.
Place one spacer over each bolt.
Step 3. Slide two bolts with assembly
into the two holes in the end plate
where previous bolts were removed.
Step 4. With 5mm hex wrench
tighten bolts rmly in place.
Step 5. Repeat Steps 1-4 on opposite
end of press.
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 • USA
Tel: (630) 971-0150 • Fax: (630) 971-1180 • E-mail: info@flexco.com
Visit www.flexco.com for other Flexco locations and products.
©2020 Flexible Steel Lacing Company. 12/01/20. For reorder: X6359
/