Novitool® Aero® Press Stand for 1525, 1835, 2135
Fabrication Considerations
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 U.S.A.
Tel: 1-630-971-0150 • Fax: 1-630-971-1180 • E-mail: info@flexco.com
Visit www.flexco.com for other Flexco locations and products.
©2017 Flexible Steel Lacing Company. Flexco® is a registered trademark. 04-03-17. For Reorder: W518
Seek the consultation of qualied engineering and fabrication resources to accommodate strength and stability
requirements prior to starting. e considerations listed below are available to aid in fabrication of an Aero® Press stand.
Designing for safety, balance, stand stability, and structural integrity
is the responsibility of the end user. e considerations provided are
for informational purposes only. e considerations are provided as
is without any guarantees or warranty as to the construction of a press
stand. In association with the considerations provided, Flexco makes
no warranties of any kind, either express or implied, including but
not limited to warranties of tness for a particular purpose. Use of
the constructed stand by a user is at the user’s risk.
Stands fabricated must accommodate:
• Max press weight 120 kg (265 lb)
• Max press length 2325 mm (91.5 in)
Top Beam weights kgs. lbs.
Aero 1525 43.6 96.2
Aero 1835 50.0 110.2
Aero 2135 56.6 124.8
2325
[91.5]
780
[30.7]
Proper splicing requires full weight of top beam be applied to belt
• Bladders reside in top beam.
• Counterweight systems must o load weight once top beam
islanded.
When constructing a stand, the builder must take into consideration:
• Potential li methods
Counterweight
Pneumatic
Hydraulic
Electric linear actuator
Crane hoist
• Li Height—15-18" target
• Accommodation for moving
Fork truck li point
Casters w/landing pads
• Leveling pads
/
