2. KVH
  3. AgilePlans TracPhone V3-HTS

KVH AgilePlans TracPhone V3-HTS Operating instructions

  • Hello! I've reviewed the labeling instructions for the KVH TracPhone V3HTS, CommBox ICM, VesseLINK and SAILOR systems. This document details the correct placement of 'Property of KVH' labels on various components. I'm ready to assist with any questions you have regarding these instructions, including where each label should be applied or what to do if you have any issues with the adhesion.
  • What is the main purpose of this document?
    Where should the 'Property of KVH' label be placed on the antenna?
    Where should the 'Property of KVH' label be placed on the ICM?
    What should you do after placing the label?
Figure 1: “Property of KVH” Label
KVH, TracPhone, AgilePlans, CommBox, and the unique light-colored dome with dark contrasting baseplate are trademarks of KVH
Industries, Inc. All other trademarks are property of their respective companies. The information in this document is subject to change without
notice. No company shall be liable for errors contained herein. © 2020-2022 KVH Industries, Inc., All rights reserved. 54-1340 Rev. B 1
AgilePlans® by KVH
TracPhone V3HTS Antenna and Ancillary Equipment
Labeling Instructions
Getting Help
If you need assistance, please contact the KVH Service Delivery Group at servicedelivery[email protected].
This document shows how to label a TracPhone®
V3-HTS system, including the antenna, ICM, and
optional accessories (i.e., Thales® VesseLINK™ or
SAILOR® 4300 Iridium Certus® system) that
comprise the AgilePlans installation.
Important!
The installer must label the equipment as shown.
This is a required step in an AgilePlans installation.
NOTE: In all cases, once the adhesive label is placed,
press firmly so that it adheres to the surface.
Label the TracPhone System
Label the antenna and ICM “Property of KVH” in
the locations indicated below.
V3-HTS Antenna Integrated CommBox Modem (ICM)
On the baseplate, centered beneath
the mini-VSAT Broadband label
Atop the ICM, at the front left-hand corner
2
Label the Thales VesseLINK 200 (if applicable)
Follow the instructions below to properly label the VesseLINK 200 system “Property of KVH.”
VesseLINK 200 Above Deck Unit (ADU) VesseLINK Below Deck Unit (BDU)
Place a clear label on the ADU radome, in the flat area
just above the baseplate, opposite the “THALES”
label.
Place a silver label on top of the BDU above the
“THALES” label.
3
Label the Thales VesseLINK 700 (if applicable)
Follow the instructions below to properly label the VesseLINK 700 system “Property of KVH.”
VesseLINK 700 Above Deck Unit (ADU) VesseLINK Below Deck Unit (BDU)
Place a clear label on the ADU radome between the
“THALES” label and the “iridium” label.
Place a silver label on top of the BDU above the
“THALES” label.
4
Label the SAILOR 4300 System (if applicable)
Follow the instructions below to properly label the SAILOR 4300 (for Iridium Certus) system “Property of
KVH.”
SAILOR 4300 Above Deck Unit (ADU) SAILOR 4300 Below Deck Unit (BDU)
Place a clear label on the ADU radome, opposite the
radiation hazard label.
Place a silver label on top of the BDU next to the
information label.
/