12
www.teejet.com
Aeros 9040 īeld computer
HOME GUIDANCEFULL SCREEN IMPLEMENTINTRODUCTION GNSS RATE CONTROL APPENDIXSETUP
CONFIGURATION
Conīæguration is used to conīægure the system components including
implements, guides, steering, monitors and sensors.
NOTE: Feature availability will vary depending on the devices
available and unlocked on the Aeros 9040 system.
1. Press SYSTEM SETUP bottom tab .
2. Press CONFIGURATION side tab .
3. Select from:
āŗImplement ā used to set (as appropriate) machine type,
GNSS antenna height, implement type, symmetric implement
layout, section output modules, number of implement
sections, application/working width, droplet size monitor,
nozzle selection, nozzle spacing, BoomPilot start mode,
reverse sense module
ā In Straight mode ā in-line/lateral implement offset direction/
distance, overlap percentage, implement delay on/off time
ā In Spreader mode:
TeeJet ā antenna to disks distance, lateral implement offset
direction/distance, overlap percentage, delay on/off times,
spread offset distance, section offset distances, section
lengths
OEM ā antenna to disks distance, lateral implement offset
direction/distance, start/stop distance, section start/stop
offset distances
ā In Staggered mode ā in-line/lateral section 1 offset
direction/distance, overlap percentage, delay on/off times,
section offsets
āŗMapping and guidance ā used to conīægure the mapping
location, guidance width, guidance sensitivity (cross track
error) and/or an optional external lightbar module (ELM)
āŗGNSS ā used to establish GNSS type, port, and PRN, as well
as to view GNSS status information
āŗVideo ā used to set up individual cameras
āŗSensors ā used to establish pressure sensor settings
āŗNozzle īow monitor ā used to establish nozzle conīæguration,
and to establish and calibrate īow limits and alarm behavior
for nozzle īow monitors
āŗISOBUS ā used to select information for broadcast over the
ISOBUS, and in troubleshooting
āŗProduct ā used to conīægure product name, tank/bin volumes,
target application rates, increment for adjusting target rates,
and colour mapping maximum/minimum rate limits and
corresponding display colours
āŗAutoSteer ā used to enable/disable and calibrate assisted/
auto steering
ā FieldPilot ā used to establish valve setup settings, steering
settings, steering wheel and steering angle sensor settings,
and to perform valve tests or valve diagnostics
ā FieldPilot Pro / UniPilot Pro ā used to manage vehicle
settings, calibrate sensors, select QI values, as well as
establish transport mode and service mode
āŗTilt correction ā used to enable/disable and calibrate the tilt
correction function, and improve application on hilly or sloped
terrain
Figure 4-2: Configuration options