(1)
5/32" Hex
Wrench
Install hardware in
the location shown
(2)
Bearing
(1)
Rail
(1)
Base
(1)
Panel
(1)
5/16-18 Screw
(2)
Button Screw
(2)
Spring Washer
(2)
Flat Washer
5/16-18 Screw
Flat Washer
Spring Washer
Bearing
Install hardware in
the location shown
Flat Washer
Bearing
Spring Washer
Black Washer
(1)
Black Washer
Reed Partition / RDXXXX
Installation Instructions
www.ghent.com/install - Lebanon, Ohio 800-543-0550
IS-RD 6/21
Step 1:
Remove and unpack the Panels, Rails, and Hardware.
Step 3:
Add the remaining hardware to the top of the Base as shown.
Step 2:
Assemble the Base as shown using the 5/16-18 Screw with a Flat Washer, then a Bearing, and
finally a Spring Washer. Please note the Spring Washer should have the cone pointed towards the Bearing.
Tighten using 5/32"
Hex Wrench
Notes
If the 5/16-18 Screw loosens when twisting the
Rail, verify that the hardware was installed
correctly per steps 2 and 3.
If the issue persists use an off-the-shelf thread
locking adhesive on the 5/16-18 Screw to
prevent loosening.
Hand tighten
No tool required
Option 1 - 64" Tall
Option 2 - 54" Tall
Reed Partition / RDXXXX
Installation Instructions
www.ghent.com/install - Lebanon, Ohio 800-543-0550
IS-RD 6/21
Step 6:
Recycle all packaging in accordance with local regulations.
Step 5:
Stand the Base upright and attache the Panel using the Button Screws. Select the desired
product height and connect multiple units
Step 4:
Add the Rail to the top of the Base, then tighten 5/16-18 Screw using the
5/32 Hex Wrench. Verify that twisting the Rail does not loosen the 5/16-18 Screw.
/
