BLOTZ B20_WW2_202, B20-WW2-202 Assembly Instructions

  • I have analyzed the provided instructions for assembling the 20mm Type T2 Mid-Section model from BLOTZ. The document outlines the necessary steps for constructing the hanger using roof, support, wall, and base pieces. It also emphasizes tools required and tips, including gluing, sanding. I'm ready to answer your questions about this construction.
  • What type of glue is required for assembly?
    What tools are needed for assembly?
    How can I hold pieces in place while the glue dries?
    What do I need to pay attention to when placing wall sections?
20mm Type T2 Hanger (Mid-Section)
B20-WW2-202
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Take the two roof sections and two central support
pieces.
Stick them to the reverse of one roof section (as
shown above)
The attach the other roof section.
Take the four angled supports
.. and glue two to each end of the roof (see pic).
The two wall sections.
Glue these to the angled supports. Note the lugs
should be at the end of the angled supports.
Take the two base pieces
You may find it helpful to glue a strip of paper / tape
underneath the base to hold the pieces together while
they dry.
Glue the angled supports and walls to the base using
the lugs / holes provided.
The completed hanger section.
/