2. BLOTZ
  3. B28-OW-631

BLOTZ B28-OW-631 Assembly Instructions

  • I have reviewed the instructions for assembling the BLOTZ 28mm Short Roof model B28-OW-631. The guide provides a step-by-step approach, explaining how to glue together the various wooden components to complete the roof. It also advises using a modeling knife for cutting pieces and sandpaper for smoothing joints. I'm here to assist you with any questions about the assembly process or the specific pieces involved.
  • What kind of glue is required?
    What tool is needed to remove pieces?
    Can I use sandpaper?
28mm Short Roof #2
B28-OW-631
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue them together as shown to form a square.
Turn this over and glue to the underside of the roof
(see pic).
Take the outer framework.
Glue a triangle to each side, aligning it with the back
edge of the roof.
Add the front strip.
Take the two inserts.
Glue one into each side frame.
Take the three strips.
Note: One is slightly longer than the other two.
Glue a shorter strip to each side of the roof and the
longer one at the top of the roof (see picture)
/