ALC AHSS31 Quick start guide

ALC
Brand
ALC
Model
AHSS31
Type
Quick start guide
QUICK START GUIDE
Motion Detector
Please read these instructions completely
before operating this product.
Model: AHSS31
Quick
Home Security Anytime from Anywhere
Quick
Simple
Set Up
ACCESSORY
Compatible with ALC AHS613, AHS616, and
AHS629 Security Systems
Operation
u
When first turning on the app you will enter the Control Hub (or
System Name you gave) Selection window. Simply tap your
Control Hub to enter.
v
The Status screen will appear. Here you can control the
connected devices as well as access the Scenario, Event and
Setting’s screens.
SCAN
TO VIEW
COMPLETE
USER’S GUIDE
For detailed installation and setup and to view the ALC 1 Year
Limited Warranty, please refer to the complete Connect Series
User’s Guide available on our website:
www.ALCWireless.com/support
Installation Pairing
For rst time use, batteries are pre-installed (3 AA batteries 3).
Apply the double-sided tape to the rear of the Motion Detector as
shown. Use the thick tape for at wall mount or the thin table for
corner mounting. Select a location between 2-2.5 meters (6-8 ft)
from the oor.
6 to 8 feet
50 feet
110 degrees detection angle
A
B
6 to 8 feet
50 feet
110 degrees detection angle
A
B
IMPORTANT: This device needs to be paired with the Control
Hub as follows.
u
Since this device is an added accessory, you should have
downloaded the Connect App and installed the ALC Control
Hub as described in the Connect Series owner’s manual.
v
At the Status screen, tap +.
w
Remove the insulating plastic tab then
open the detector by pressing the tab
at the bottom. Press the Pair button.
x
Tap Motion Detector. Tap Pair and
follow the on screen instructions.
At the final screen, enter the Motion
Detector’s name and location and tap
Save.
This Motion Detector is an accessory to be used along with the
Connect series Control Hub Kit. Please refer to this quick start
guide as well as the Connect series owner’s manual, see back
cover for details.
Trouble Pairing?
If it did not detect the
detector, remove the
battery for 5 seconds
and press the Pair button
again. Repeat step 4.
  • Page 1 1
  • Page 2 2

ALC AHSS31 Quick start guide

ALC
Brand
ALC
Model
AHSS31
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents