Installation Pairing
A CR2032 battery has been pre-installed in the Door/Window
Sensor for rst time use. Apply the double-sided tape to the rear
of both sections of the Door/Window sensor. Select a location on
either a door or a window. Make sure to attach the smaller piece
to the movable part of the door/window frame.
IMPORTANT: This device needs to be paired with the Control
Hub as follows.
u
Since this device is an added accessory,
you should have downloaded the Connect
App and installed the ALC Control Hub as
described in the Connect Series owner’s
manual.
v
At the Status screen, tap +.
w
Remove the insulating plastic tab, then tap Door/Window
Sensor. Tap Pair and follow the on screen instructions. At
the final screen, enter the sensor’s name and location and tap
Save.
This Door/Window Sensor is an accessory to be used along
with the Connect series Control Hub Kit. Please refer to this
quick start guide as well as the Connect series owner’s manual,
see back cover for details.
Trouble Pairing?
If it did not detect the sensor, remove the battery for 5-10
seconds and then repeat.