2. Computers & electronics
  3. Print & Scan
  4. Bar code readers
  5. Unitech
  6. FC75

Unitech FC75 Quick start guide

  • Hello! I'm here to assist you with your FC75 barcode scanner. I've reviewed the quick start guide, and I'm ready to answer your questions about connecting the device, setting it up for hands-free use, and configuring its scanning modes.
  • How do I connect the FC75 to a computer?
    How do I mount the FC75 for hands-free scanning?
    How can I test the device is working?
    What is the "Tab Mode"?
    What is the "Enter Mode"?
    How do I reset the scanner to its factory settings?
FC75 QUICK START GUIDE
Scan this series of barcodes to switch to Tab Mode (continued on next page).
100
Tab Mode
Tab Mode Start
You may wish to set your scanner to “Tab Mode.” In this
mode, data will tab over to the next column as you scan
instead of jumping to the next line. Scan here to begin.
TAB MODE Start TAB MODE
Tab Mode
The following section covers the most common conguration settings for
your FC75 scanner.
For additional conguration options please visit
unitechscanners.com/FC75 and select the “Download” tab.
You will nd the User’s Manual and a variety of other resources.
SEttings and configuration
Tab Mode
Open a word processing program such as Microsoft Word or Notepad on
your host. Now scan the following barcode:
If the word “Unitech” appears on the screen you have succesfully installed
your scanner. Congratulations!
TEST AND FINISH
Step 3:
Plug the FC75’s interface cable into a USB port of a
host computer.
*Your host computer may take a moment to recognize
the FC75 scanner.
connectING THE FC75 TO A HOST COMPUTER
Step 1:
Tab Mode
Guide the four screws into the
holes in the hands-free stand.
Use a screwdriver to nish the
installation.
*The hands-free stand is an
optional accessory
Mounting the FC75 (hands free scanning)
Step 2:
(4) M3X5 SCREWS
FC75
FC75 QUICK START GUIDE
Tab Mode
Scan this series of barcodes to switch to Enter Mode.
1013
Enter Mode
Tab Mode
Tab Mode Finish
Scan here to enter your settings.
You are now in Tab Mode.
tab mode finish Tab Mode
Enter Mode Start
You may wish to switch back to “Enter Mode.”
Scan here to begin.
enter mode
Scan here to return your scanner to its original factory settings, a useful
feature for troubleshooting purposes.
Scan here to enter your settings. You are now in Enter Mode.
Enter Barcode
The FC75 is a plug-and-play scanner. It does not require a driver and
should be recognized as a generic HID device by your computer, similar
to a standard keyboard. This allows you to scan into any eld that you
could normally type into.
Unitech’s professional support team is available to quickly answer
questions or technical-related issues. Should equipment issues occur,
please contact a Unitech Support Engineer at (800) 861-8648 for more
information.
Tab Mode
Questions / Problems?
Tab Mode
Enter mode finish Tab Mode
Factory Default
© 2014 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Tab Mode
TAB mode continued
Enter Barcode
Continue Scanning.
9
/