Instructions
Manitowoc Beverage Systems Sellersburg, 2100 Future Drive, Sellersburg, IN 47172, Tel: 812-246-7000, www.manitowocbeverage.com
1/11
Subject: Extended Splash Panel Brackets
CHANGE
These instructions are to be used to install the extended splash panel brackets on the S-250M.
TOOLS NEEDED
• Phillips Head Screwdriver
• Drill
• #29 Drill Bit
1. Using a phillips head screwdriver, remove the existing right & left
splash panel screws and remove the splash panel.
2. Using a phillips head screwdriver, remove the right & left splash panel
bracket screws and brackets (FIGURE 1).
3. Locate the bottom 2 holes directly below where the brackets were
removed in step 1 and drill through the foam front using a drill and a #29
drill bit (FIGURE 2). Drilling into the foam front is necessary to allow room
for the new extended splash panel bracket screws to be installed.
NOTE: Figure 2 shows where the new brackets go compared to the
existing brackets. Existing brackets still need to be removed as
instructed in step 2.
4. Install the new extended splash panel brackets with a phillips head
screwdriver using the provided screws into the bottom 2 holes drilled out
in step 3 (FIGURE 3).
5. Install the extended splash panel using a phillips head screwdriver to
tighten the flat head screws into the new brackets.
OLD BRACKET
NEW BRACKET
HOLES
FIGURE 3
FIGURE 1
FIGURE 2
/
