Midmark Integra™ Operatory Cabinetry - Side Cabinetry Installation guide

Type
Installation guide
1
© Midmark Corporation 2007
DA184200i
LOGO
Quartz / Corian Countertop Installation
003-1726-00 Rev. (A)
Components:
Countertop .......... 1
Adhesive Sealant 1
Back Splash ........ 1
Sink Bowl ......... AR
Sink Hardware . AR
Special Tools:
none
Note
Read directions on adhesive
sealant before using.
Sink Units only
Step 2: Align logo with back of sink cutout.
Making sure there is an even amount
of space around the cutout and sink.
Press sink to bottom of countertop.
Sink Units only
(go to Step 5 if not applicable)
Step 1: Apply adhesive (provided)
to sink as shown.
Quartz Countertops
Corian Countertops
Sink Units only
(go to Step 4 if not applicable)
Step 3: Insert four anchor bolts into slots,
then place sink clips onto bolts.
Secure sink with washers and nuts.
Sink Units only
Step 4: Align sink clip, washer, wing nut
and screw as shown. Tighten
screw to bottom of counter top.
Using wing nut to tighten sink clip
to sink.
Next
Style A
2
© Midmark Corporation 2007
DA184300i
Midmark Corporation
60 Vista Drive
Versailles, OH 45380-0286
Phone: 937-526-3662
Fax: 937-526-5542
www.midmark.com
Step 7: Apply adhesive sealant
to top countertop and back
of back splash.
Step 8: Line up back splash flush to wall
and secure to back of countertop.
Step 5: Using provided adhesive
sealant put a bead on top
surface of cabinet.
Step 6: Line up countertop to cabinet
and secure by push countertop
tightly against cabinet.
Note: Midmark recommend if countertop is
large to use 2 installers for this procedure.
Note
Midmark recommends to use
waterproof cault to seal back
splash. (Not provided)
Back
  • Page 1 1
  • Page 2 2

Midmark Integra™ Operatory Cabinetry - Side Cabinetry Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI