1 Introduction

The Hot Wire Cutter is primarily for the use of cutting Danfoss

SpeedUp panels as well as additional EPS or XPS insulation.

Please be careful when working with the tool to prevent accidents

such as burning yourself or your surroundings. The blades can

reach temperatures of up to 500 °C. Never touch the blade after

the switch has been pressed down. Do not lay the unit against any

surface after use until the blade has cooled down.

Do not operate the product in unfavourable ambient conditions,

Strong vibrations.

2 Technical Data

Ordering 088X0612

Type FH-TOM

Operating Voltage 230 V~ 50-60 Hz (110 V~ 50-60 Hz)

Power Consumption 60 W

Intermittent Operation 12s ON / 48s OFF

Weight 1025 g

2.1 Cutting Blades

U-shaped blade for 16 mm grooves

reasons (CE).

▪

The connection cable is to be replaced only by the

manufacturer or his servicing agent who have a special tool

available.

▪

The structure of the Hot Wire Cutter complies with safety

class II. Make sure that the insulation of the housing is neither

damaged nor destroyed.

Installation Guide

3. Tighten binding screws again carefully.

4.

Before you plug in the tool, check the voltage which is

indicated on the label.

5. When you press down the switch the cutting blade heats up.

After about 6-8 secs. the suitable cutting temperature is

obtained.

6. The blade may be cleaned with a metal brush while it is still

warm.

7. After working release the switch of the Hot Wire Cutter.

down for 3/4 minute.

5 Disposal

The device itself must not be disposed in household refuse!

An unusable device must be returned to the supplier, the

manufacturer or an official disposal body/institution equipped for

this purpose.

6 CE-mark

This device fulfil the requirements of the EU-Directives:

2004/108/EC: „EMC-Directive“

Heating Solutions

Haarupvaenget 11

8600 Silkeborg

Denmark

Phone:+45 7488 8000

Fax: +45 7488 8100

Email: [email protected]

www.heating.danfoss.com

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products

already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective