Hukoro F52315-11i User manual

Type
User manual

This manual is also suitable for

Wire
strippers
Ladder Safety
glasses
Electrical
tape
Phillips
screwdriver
PliersFlat blade
screwdriver
CAUTION
Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect
in the wire, do not attempt installation.
Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by
removing the fuse at the fuse box.
Bulbs
(not included)
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
EXPLODED PARTS INSTALLATION
STEP 1
Attach the iron rack B into iron rack A
using screws A a as shown.
STEP 2
Attach the iron rack C into iron rack B
using nuts.
Attach the iron rack C and fixture into
iron rack A using screws B.
STEP 3
1. Unscrew the ball nuts and
green grounding screw from
the mounting unit.
2. Disassemble the swivels under
the ceiling plate by unscrewing
decorative nuts. Keep the
baseplate, washers, ground wire
and lanyards for latar use.
HARDWARE INCLUDED
Fixture
Fixture Iron Rack A Iron Rack B Iron Rack C
Iron Rack C
Nuts
Iron Rack B
Iron Rack A
Ball Nuts
Ball Nuts
Screws A Screws B Nuts
Screws B
Screws A
Stems Swivels
Swivels
Ceiling Plate
Mounting
Screws
Mounting Screws
Wire Nuts
Wire Nuts
Washers Ground
Wire
Ground
Wire
Mounting Unit
Mounting Unit
Baseplate LanyardsDecorative
Nuts
Decorative
Nuts
Wood
Screws
Wood Screws
Wall
Anchors
Wall Anchors
Stem
Stem
Stem
Stem
Ceiling Plate
Washers
Baseplate
Lanyards
1
2
a
a
b
b
1. Weave the fixture wire and fixture ground wire
through the stems and swivel.
2. Install swivels and stems into the fixture.
Install stems based on the desired length of
the item on the fixture.
ASSEMBLY INSTRUCTIONS INSTALLATION
STEP 8
STEP 4
1. Attach the lanyards on to the mounting unit.
2. Make the electrical connection from the junction box to the fixture. Connect the
ground wire to the mounting unit using the preinstalled green ground screw.
Then, connect the positive, negative and ground wires with the supplied wire nuts.
Secure with electrical tape.
STEP 7
1. Weave the fixture wire and
fixture ground wire through
the ceiling plate, baseplate,
ground wire, lanyards,
washer and decorative nut.
2. Install baseplate, lanyards,
ground wire and swivels into
the ceiling plate, and secure
with washers and decorative nuts.
STEP 5
Attach the mounting unit to
the junction box using the
mounting screws.
Secure mounting unit to
ceiling with wood screws
and wall anchors.
STEP 6
Attach the ceiling plate to the mounting unit through
screw holes as shown, and secure it with ball nuts.
STEP 9
Install bulbs (not included)
1
2
White wire from
the fixture
Ground wire from
the Fixture
Black wire from
the fixture
Black or Red wire (hot)
from the junction box
White wire (neutral)
from the junction box
Bare or Green ground wire
from the junction box
*Green Ground Screw
*Sealing tape
(not included)
  • Page 1 1
  • Page 2 2

Hukoro F52315-11i User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI