ROOMS TO GO 90600593 Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the UTTERMOST light fixture 21346. This document provides a detailed step-by-step guide on how to install the fixture safely and correctly. It covers everything from unpacking to wiring and attaching the glass shades. I'm here to answer your questions about the installation process or any other aspect of the fixture as described in the document.
  • What should I do before starting the installation?
    Do I need professional help to install this light fixture?
    How do I make wire connections?
21346
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER
WHILE POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
We suggest a licensed professional electrician for installation
Installation Steps
1. Turn power off at fuse or circuit box before
starting installation process.
2. Carefully unpack your new fixture and lay out
all the parts on a clear surface.
3.
Choose the suitable number of stems and
install the Stem-1, Stem-2 into the Tube.
4. Please loose the Hex nut and disassemble
Swivels.
5.
Thread the Swivels into the Stem-1.
6. Insert the nipples of Swivels into holes in
Canopy, then place the Iron plate, the Support
cable, the lock washers over the nipples, then
secure with the Hex nuts.
7. Thread the Mounting screws into the matching
holes of the Circular strap, and tighten with the
Small hex nut. Thread the Ground screw into
the hole of the Circular strap. Secure the
Circular strap to the outlet box with the Outlet
box screws.
8. Attach the Hooks on the end of the Support
cables to the Circular strap.
9. Make Wire connections with Wire Connector:
---The smooth wire (w/ marking) from fixture to
Black Wire from power source.
---The ribbed wire (w/o marking) from Fixture to
White Wire from power source.
---Attach the Ground Wire and house ground wire to the Mounting bar with the green Ground
screw.
Carefully tuck wires back into the Outlet Box.
10. Place the fixture Canopy over the two Mounting screws so they protrude through the holes in
the Canopy. Thread the Ball nut onto the Mounting screws and continue turning until the
fixture is snug against the ceiling.
11. Slide the Glass shades over the Sockets, then secure with the Socket rings.
12. Install the light bulbs (Not Supplied) in accordance with the fixture’s specifications.
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
P.O. Box 558 | 3325 Grassy Hill Road | Rocky Mount, VA | 24151
www.uttermost.com
WARNING:
/