Hukoro F88702-11i User manual

Brand: Hukoro

Model: F88702-11i

Type: User manual

Wire

strippers

Ladder Safety

glasses

Electrical

tape

Phillips

screwdriver

PliersFlat blade

screwdriver

CAUTION

Inspect the wire insulation for any cuts,

abrasions, or exposed copper that may have

resulted during shipping. If there is a defect

in the wire, do not attempt installation.

Before starting installation of this ﬁxture or

removal of a previous ﬁxture, disconnect the

power by turning oﬀ the circuit breaker or by

removing the fuse at the fuse box.

Bulbs

(not included)

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED

EXPLODED PARTS INSTALLATION

STEP 1

Unscrew the ball nuts from the mounting unit.

Use the mounting screws to attach the mounting unit

to the junction box.

HARDWARE INCLUDED

Fixture

Mounting Unit

Mounting Screws

Wire Nuts

Fixture Mounting Unit Mounting Screws Wire NutsBall Nuts Rubber Rings

Ball Nuts

Rubber ring

Make the electrical connection from the junction box to the ﬁxture.

Connect the ground wire to the mounting unit using the preinstalled

green ground screw. Then, connect the positive, negative and

ground wires with the supplied wire nuts. Secure with electrical tape.

STEP 2

White wire from

the ﬁxture

Ground wire from

the Fixture

Black wire from

the ﬁxture

Black or Red wire (hot)

from the junction box

White wire (neutral)

from the junction box

Bare or Green ground wire

from the junction box

*Green Ground Screw

*Sealing tape

(not included)

ASSEMBLY INSTRUCTIONS INSTALLATION

STEP 4

Attach the ﬁxture to the mounting unit through screw holes

as shown, and secure it with rubber rings and ball nuts.

STEP 3

Install bulb (not included)

NOTICE: Please use caulk in the back plate and wall

mounting surface to prevent water from entering.

1
2

Hukoro F88702-11i User manual

Brand: Hukoro

Model: F88702-11i

Type: User manual

Related papers

Other documents