Uixe SSL-12171 User manual

Type
User manual
Wire
strippers
Ladder Safety
glasses
Electrical
tape
Phillips
screwdriver
PliersFlat blade
screwdriver
CAUTION
Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect
in the wire, do not attempt installation.
Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by
removing the fuse at the fuse box.
Bulbs
(not included)
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
EXPLODED PARTS INSTALLATION
STEP 1
Unscrew the rubber rings and ball nuts from the mounting unit.
Use the mounting screws to attach the mounting unit
to the junction box (not included).
HARDWARE INCLUDED
Ball Nuts
Fixture
Mounting Unit
Mounting Screws
Wire Nuts
Junction Box (not included)
Fixture Mounting Unit Mounting Screws Wire NutsBall NutsRubber Rings
Rubber Rings
Make the electrical connection from the junction (not included) box to the
fixture. Connect the ground wire to the mounting unit using the preinstalled
green ground screw. Next, connect the positive, negative and ground wires
with the supplied wire nuts. Secure with electrical tape.
STEP 2
White wire from
the fixture
Ground wire from
the Fixture
Black wire from
the fixture
Black or Red wire (hot)
from the junction box
White wire (neutral)
from the junction box
Bare or Green ground wire
from the junction box
*Green Ground Screw
*Sealing tape
(not included)
ASSEMBLY INSTRUCTIONS INSTALLATION
STEP 4
Install bulb (not included)
Attach the fixture to the mounting unit through screw holes
as show,and secure it with rubber rings and ball nuts.
*junction box
(not included)
STEP 3
NOTICE: Please use caulk in the back plate and wall
mounting surface to prevent water from entering.
  • Page 1 1
  • Page 2 2

Uixe SSL-12171 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI