2. BLOTZ
  3. B20-ME-102

BLOTZ B20-ME-102, B20_ME_102, BH0-ME-102 Assembly Instructions

  • Hello, I'm your chat assistant. I've reviewed the instructions for the Desert Fort Long Wall - Gates model. The document provides clear steps for assembling the fort, including optional door placement and gate installation. I am ready to answer questions about constructing this model based on the provided instructions.
  • What kind of glue is needed?
    Can the gates be glued?
    What is needed to cut parts from sprue?
20mm Desert Fort – Long Wall - Gates
B20-ME-102
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Turn the “roof” upside down and attach the other
pieces to it as shown.
Add the front wall.
[Optional] Glue a door behind each doorway.
Place (do not glue) the gates into their holes.
Turn the model the right way up and attack the
base, slotting each lug into the associated hole.
Add the two steps above the entrance.
The finished model.
/