Anova RCPHEXHLD Assembly Instruction

Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.

anovafurnishings.com

888.535.5005 tel

TOOLS NEEDED:

• Rotary hammer drill

• Drill with 1/4" drill bit

• Hammer

Assembly Instructions

Accessories

RCPHEXHLD - Hexagon Picnic Table Hold Down Kit

HOLD DOWN KIT COMPONENTS:

(3) 1/4" X 3" Nail Anchors (1) 1/4" Masonry Drill Bit

INSTALLATION ON CONCRETE SLAB:

Inspect the shipping container contents for damage and to

determine that all components are present.

Use a drill with a 1/4” drill bit to drill a hole through the

base board of each of the table seats.

Position the RCPHEX table in the desired location and mark

the position of each of the seat base holes on the concrete

slab.

Move the table so you can use a rotary hammer drill with

the included 1/4” masonry drill bit to drill a hole at each

marked location about 1 1/2” deep into the concrete.

Reposition the table so the seat base holes align with the

concrete slab holes.

Insert the nail anchors through each of the seat bases and

into the holes in the concrete slab. Set each nail anchor

with the hammer.

Drill 1/4" hole through

each seat base

1/4" Nail Anchor