Hammer Drill
Masonry Drill Bit Set
1/4" & 16/64"
Hammer
7/16 "Wrench
Safety Glasses
anovafurnishings.com
888.535.5005 tel
TOOLS NEEDED: HARDWARE NEEDED:
Installation Instructions
All Element Receptacles Surface Mount
Step-by-Step Installation Sequence
Product ships fully assembled.
Examine the footing or slab for damage or defects. The footing or slab should be reinforced concrete rated at a
3,000 psi minimum and be cured for at least 28 days prior to the installation of the receptacle.
CAUTION: Oversized holes and holes drilled too deep in the concrete will make it dicult to set the anchor.
!
Drill
A. (2) 3/4” x 1-5/16” x 2-1/4” Brackets
B. (2) 1/4” x 1-1/2” Lag Screws
C. (2) 1/4” x 1-1/2” Masonry Anchors
D. (2) 1/4-20 x 3/4” Self Threading Screws
PANELHLD hold down Kit
06/26/2019 Copyright 2019 ANOVA® Manufactured in the U.S.
Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.
Installation Instructions
Step-by-Step Installation Sequence
1.
3.
4.
6.
5.
1. Position the receptacle and the bracket (A) on the oor with the short side
of the bracket at on the oor and the long side against the corner of the
frame.
Insert a 1/4-20 x 3/4” screw (D) through the bracket and into the hole in the
bottom frame and tighten in place.
Install the remaining bracket on the opposite corner of the receptacle in the
same manner.
To install on wood oors, use your drill and 13/64” drill bit to drill a hole 1-3/4”
deep through the horizontal hole in the bracket and into the oor. Then insert
a lag screw (B) through the bracket into the hole in the oor and tighten in
place. Repeat this step for the opposite corner.
To install on concrete, use your rotary hammer drill and a 1/4” masonry drill
bit to drill a hole 1-3/4” deep in the concrete through the horizontal hole in
the bracket. Then insert a masonry nail anchor (C) through the bracket and
into the hole in the concrete and hammer the pin until ush with the top of
the bracket. Repeat this step for the opposite corner.
2. Using your drill and 13/64” drill bit, drill through the vertical hole in the
bracket and through the bottom frame of the receptacle.
All Element Receptacles Surface Mount
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Anova RCPHEXHLD Assembly Instruction
-
-
-
-
-
-
-
-
-
Other documents
-
VersaTube VS3406014420SG User manual
-
VersaTube CM018200070 User manual
-
VersaTube Building Systems ZINST-CV40 User manual
-
Arrow LX102 Owner's manual
-
-
Craftsman CVCS107 Installation guide
-
-
-
-
Arrow LW108 Owner's manual
