2. Anova
  3. RCPHEXHLD

Anova RCPHEXHLD Assembly Instruction

  • Hello! I've reviewed the Assembly Instructions for the ANOVA RCPHEXHLD Hexagon Picnic Table Hold Down Kit. This document outlines the necessary steps, tools and parts needed to securely install your picnic table on a concrete slab using nail anchors. I am ready to answer your questions about the document and the installation process.
  • What tools are needed for installation?
    What components are included in the hold down kit?
    How deep should the holes be drilled into the concrete?
01/24/2018 Copyright 2018 ANOVA® Made in USA. 1
Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.
anovafurnishings.com
888.535.5005 tel
TOOLS NEEDED:
• Rotary hammer drill
• Drill with 1/4" drill bit
• Hammer
Assembly Instructions
Accessories
RCPHEXHLD - Hexagon Picnic Table Hold Down Kit
HOLD DOWN KIT COMPONENTS:
(3) 1/4" X 3" Nail Anchors (1) 1/4" Masonry Drill Bit
INSTALLATION ON CONCRETE SLAB:
Inspect the shipping container contents for damage and to
determine that all components are present.
1.
Use a drill with a 1/4” drill bit to drill a hole through the
base board of each of the table seats.
2.
1
Position the RCPHEX table in the desired location and mark
the position of each of the seat base holes on the concrete
slab.
3.
Move the table so you can use a rotary hammer drill with
the included 1/4” masonry drill bit to drill a hole at each
marked location about 1 1/2” deep into the concrete.
4.
Reposition the table so the seat base holes align with the
concrete slab holes.
5.
Insert the nail anchors through each of the seat bases and
into the holes in the concrete slab. Set each nail anchor
with the hammer.
6.
Drill 1/4" hole through
each seat base
1/4" Nail Anchor
/