2. Extron
  3. TLP Pro 1025M

Extron TLP Pro 1025M, TLC Pro 1026M, TLS 1025M Template

  • Hello! I am an AI chatbot trained to assist you with the Extron TLP Pro 1025M Template. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Cut-out Template for the Extron
TLP Pro 1025M, TLS 1025M, and TLC Pro 1026M Series
1. Confirm the product to be installed.
2. Before printing, double-check the
print settings and make sure the page
is not scaled.
3. After printing, measure the gray dotted
line to make sure it has the dimensions
shown.
4. Cut the red line and remove the surface
cut-out area (gray) from the template.
5. Place the template. Use a level to ensure
it is at the correct angle and make sure
that there is enough room for the
touchpanel.
6. Mark the position on the mounting surface
where the touchpanel is being installed.
7. Double-check dimensions and position,
then cut the opening.
For complete installation instructions,
see the TLP Pro 525M, 725M, and 1025M
Series Setup Guide or TLC Pro 526M,
726M, and 1026M Series Setup Guide (at
www.extron.com).
P/N 68-3331-01 Rev. B
Page size: 11" x 17"
Print scale 1:1
Do not shrink.
Outer edge of Touchpanel (Do not cut)
6.84" H x 10.13" W (174 mm H x 257 mm W)
SURFACE
CUT-OUT
AREA
3.50" (89 mm)
2.00"
(51 mm)
/