2. 3M
  3. Imprint™ II VPS Impression Material

3M Imprint™ II VPS Impression Material User guide

  • Hello! I am an AI chatbot trained to assist you with the 3M Imprint™ II VPS Impression Material User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
ONE-STEP/TWO VISCOSITY TECHNIQUE
Imprint
™
II Impression Material
5
1 of 4
• To remove the cartridge cap, rotate it
90° in a counter-clockwise direction (A).
• With firm pressure, tilt the cap
downward and peel it away from the
cartridge (B).
3
4
• For initial use extrude a small amount
of material and discard it. Wait for a
uniform mix.
• Locate the V-Notch on the cartridge
flange. The V-Notch must be facing
down as the cartridge is loaded into the
3M
™
ESPE
™
Garant
™
Dispenser.
1
2
• Apply VPS Tray Adhesive: dry a
minimum of 5 minutes.
• Insert the loaded Penta cartridge into the
3M
™
ESPE
™
Pentamix
™
Mixing Unit.
ONE-STEP/TWO VISCOSITY TECHNIQUE
Imprint
™
II Impression Material
2 of 4
• Bleed the cartridge.
• Locate and align the V-Notch on the
mix tip with the V-Notch between the
cartridge barrels.
6
7
8
• To attach the mix tip, hold the mix tip
collar and push firmly to ensure that it is
flush with the cartridge (A).
• Rotate the collar 90° in a clockwise
direction to its locked position (B).
9
• Attach an intraoral tip to the light body
material mix tip (A) or load an intraoral
syringe (B).
10
• Syringe light body material around the
clean, dry tooth preparation(s) using
either 3M
™
ESPE
™
Imprint
™
II Garant
™
Light Body (A) or 3M
™
ESPE
™
Imprint
™
II Garant
™
Regular Body (B).
ONE-STEP/TWO VISCOSITY TECHNIQUE
Imprint
™
II Impression Material
3 of 4
15
• 3M ESPE recommends horizontal
storage of the ready-for-use cartridges.
13
14
• Immobilize the tray using passive
pressure. Oral Set Time: 4 minutes.
• Remove the impression, rinse, dry and
disinfect. Wait 30 minutes to pour the
stone model.
11
12
• Begin filling the tray.
• Slowly seat the tray in the mouth.
ONE-STEP/TWO VISCOSITY TECHNIQUE
Imprint
™
II Impression Material
4 of 4
3M ESPE Customer Hotline 1-800-634-2249 70-2009-3425-8B
Please refer to instructions for more detailed information
as well as precautionary and warranty information. © 2003 3M
Important Information:
Imprint II cartridges are specifically designed for use with the
Garant
™
Dispenser.
• Avoid contact with chemicals known to inhibit the set of vinyl
polysiloxane materials such as latex rubber, acrylic and
methacrylate residues.
• To avoid inhibition caused by temporary materials, the final
impression should be made before fabricating the provisional
crown or bridge.
/