Astonica 50101041 User manual

Brand: Astonica

Model: 50101041

Type: User manual

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,

DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT

1-888-424-3354

Read the instructions and precautions before use of this product

Please keep this instruction manual for future reference

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,

DO NOT RETURN IT TO YOUR RETAILER, CONTACT CONSUMER SUPPORT AT

1-888-424-3354

IF YOU ARE A STORE MANAGER OR EMPLOYEE IN NEED OF ASSISTANCE CALL

1-888-851-5569

PLEASE HAVE YOUR STORE NUMBER READY

Limited Warranty

World Factory, Inc.

Products for Home Use

World Factory, Inc.

(Seller) warrants to the original Buyer only, that each Astonica

Product will be

free from defects in material and workmanship for a period of one (1) year from date of purchase.

SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED

WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH

ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE

SELLER WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY

FROM REPAIRS OR ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER

MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This

warranty does not apply to damage, heat-induced coloration changes, scratching or alteration due to

normal use or weathering. To make a claim under this Limited Warranty, you must return the complete

product with proof of purchase, transportation prepaid, to any World Factory, Inc.

authorized service

center. Call 1-888-424-3354 for the location of the nearest authorized service center.

Additional Limitations

THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED

TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1)

YEAR FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY

INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR

LOSS OF PROFITS, ARISING FROM THE SALE OR USE OF THIS PRODUCT.

If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such

provision shall not affect any other provision herein, this Limited Warranty shall be construed as if

such invalid and/or unenforceable provision had never been contained herein.

This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all

prior agreements, arrangements, or understandings between the parties relating to product warranty.

Made in China

Distributed by:

World Factory, Inc.

Coppell, TX 75019

Model No: 50101041

Due to ongoing product development

the actual product or products may vary from

the illustrations or photos shown within this manual.

Curved Back Basket Weave Bench

Instruction Manual

221004rev1

NOTE: This product is intended for residential, non-commercial use.

Carefully remove the contents from the package. If any parts are missing do not

attempt to use the product until they have been obtained and correctly installed.

ASSEMBLY INSTRUCTIONS

CAUTION: Do not over tighten fasteners.

Figure 1

Figure 2

2.(SEE FIGURE 2) Attach the wood slats (B)

 to the arm and leg support (C) using

 washer (f), and nut (G).

 Repeat on the other side and do not tighten

 bolts until all wood slats (B) are in place and

 bench is at 90 degrees with floor.

1.(SEE FIGURE 1) Using Bolts (E) washers (F)

 and nuts (G) attach one end of the arched

 bench back (A) to the leg & arm brace (C).

 Attached the other end of the back to the

 second leg & arm brace (C).

3.(SEE FIGURE 3) Turn the bench over on a

 non-scratch surface and attach middle

 support bracket (D) to the slats (B) at the

 midway point between legs (C) using wood

 screws (H). Work from the front to back,

 bending bracket (D) as necessary to fit the

 contour of the bench.

Figure 3

PARTS & HARDWARE LIST

PART # DESCRIPTION QUANTITY

A 1Arched Bench Back

B 5Wood Seat Slats

C 2Cast Iron Legs & Arm Brace

D 1

Middle Support Bracket

Bolt 6mm x 32mm

E 14

Washer 6mm

F 14

Nut 6mm

G 14

Phillips Wood Screw

Plastic Nut Cover

4.Ensure all fasteners are securely tightened.

Place plastic nut cover over nuts (G) located

on backside of bench, 4-places.

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,

DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT

1-888-424-3354.

NOTE: This product is intended for residential, non-commercial use.

Astonica 50101041 User manual

Astonica 50101041 User manual

Astonica 50101041 User manual

Related papers

Other documents