2. CLD
  3. ARS20HFS Street Legal Light Bar Driving + Fog + Strobe

CLD ARS20HFS Street Legal Light Bar Driving + Fog + Strobe, BARS20HFS Street Legal Light Bar Driving + Fog + Strobe User manual

  • I've reviewed the user manual for the CLDBARS20HFS light bar, which features driving, fog, and strobe modes, along with mounting instructions. The manual also details the light bar's specifications, including light output, voltage, and power. I'm ready to answer your questions.
  • What is the total light output of the light bar?
    What are the available light modes?
    What are the strobe flash patterns?
    What is the voltage range for the light bar?
SKU# CLDBARS20HFS CLDLED.COM
1
WHAT’S INCLUDED:
1 X Light Bar
Side and Bottom Mount Brackets & Hardware
STREET LEGAL LIGHT BAR
DRIVING + FOG + STROBE
CLDBARS20HFS
FEATURES & SPECIFICATIONS:
Light Output: 3,478+1,430+680 Lumens
Power: 144W @ 13.6V DC
Voltage: 10 - 36V DC
Beam Patterns & Compliance:
Driving Beam (SAE J581)
Fog Light (SAE J583)
Strobe (3 Flash Patterns)
Dimensions: mm
MOUNTING INSTALL INSTRUCTION
SKU# CLDBARS20HFS CLDLED.COM
2
INSTALL INSTRUCTION
Wiring harness with 1 DT 4-Pin connector
(CLDWH14 sold separately)
Or Wiring harness with 2 DT 4-Pin connectors
(CLDWH24 sold separately)
1. Determine suitable mounting locations to install the LED light bars, wiring harness and switch panel.
Once all mounting locations are confirmed, connect the wires as shown above. Proper insulation at
connections is required.
2. Connect positive and negative wire properly. Press the switch buttons to test if each mode is
functioning properly.
3. Adjust the light to the desired angle and then secure by tightening all mounting screws.
4. There are 3 flash patterns available: Hyper Burst, Quick Strobe and Slow Strobe.
5. Turn the strobe light off for at least 2 seconds, then quickly turn the strobe switch ON-OFF-ON and
the strobe light will switch to next pattern.
6. Memory function: the last running strobe mode is automatically saved as the default strobe one.
/