2. CLD
  3. BAR12 Slim Single Row Light Bar

CLD BAR12 Slim Single Row Light Bar, AR12 Slim Single Row Light Bar User manual

  • Hello! I have reviewed the user manual for the CLD SLIM SINGLE ROW LED Light Bar series (including models CLDBAR12, CLDBAR20, CLDBAR30, CLDBAR40, CLDBAR50, CLDBAR20C, CLDBAR30C, CLDBAR40C, CLDBAR50C). This manual covers the installation, mounting and specification of the unit, which features OSRAM P8 LEDs, a spot/flood beam, and several mounting options. I'm ready to answer your questions about this product.
  • What is included with the straight LED light bar?
    What is included with the curved LED light bar?
    What are the available lengths for the straight LED bar?
    What are the available lengths for the curved LED bar?
    What is the beam pattern of the LED light bar?
SKU# CLDBAR12 / CLDBAR20 / CLDBAR30 / CLDBAR40 / CLDBAR50 / CLDBAR20C / CLDBAR30C / CLDBAR40C / CLDBAR50C CLDLED.COM
1
WHAT’S INCLUDED (STRAIGHT BAR):
1 x LED Light Bar
Side and Bottom Mounting Brackets & Hardware
WHAT’S INCLUDED (CURVED BAR):
1 x LED Light Bar
Side Mounting Brackets & Hardware
SLIM SINGLE ROW LIGHT BAR
CLDBAR12 / CLDBAR20 / CLDBAR30 / CLDBAR40 /
CLDBAR50 / CLDBAR20C / CLDBAR30C /
CLDBAR40C / CLDBAR50C
FEATURES & SPECIFICATIONS:
Light Output: 3,220 - 14,230 Lumens
LEDs: OSRAM P8
Power: 60W - 300W @ 13.6V DC
Voltage: 10 - 36V DC
Optional Length:
12", 20", 30", 40" and 50" for Straight Bars
20", 30", 40" and 50" for Curved Bars
Beam Pattern: Spot/Flood Combo
20" Straight Light Bar (For Example)
MOUNTING INSTALL INSTRUCTION
20" Curved Light Bar (For Example)
Dimensions: mm
Side Mounts
Bottom Mounts (ONLY FOR STRAIGHT BAR)
SKU# CLDBAR12 / CLDBAR20 / CLDBAR30 / CLDBAR40 / CLDBAR50 / CLDBAR20C / CLDBAR30C / CLDBAR40C / CLDBAR50C CLDLED.COM
2
INSTALL INSTRUCTION
For Two 12" Light Bars
For One 12", 20", 30", 40" or 50" Light Bar
1. Determine the appropriate mounting locations to install the LED light bars, wiring harness and
switch. Once all mounting locations are confirmed, connect the wires as shown above. Proper
insulation at connections is required.
2. Connect positive wire and negative wire properly. Press the switch to test if the lights are working
properly.
3. Adjust the light to the desired angle and then secure by tightening all mounting screws.
/