2. Centerline
  3. Hot Door Type Tri Wash Arm Kit

Centerline Hot Door Type Tri Wash Arm Kit Installation guide

  • Hello! I've reviewed the installation instructions for the HOBART Ecoline 00-563658 Wash Arm Kit. This document provides details on how to install the components of the kit, including the plastic bushing, shaft, and tri-arm components, with a cure time of at least 6 hours after applying the necessary sealant. I am ready to answer any questions you have about it.
  • What model is this kit intended for?
    Who should perform this installation?
    How long should the Loctite cure before using the dishwasher?
INSTALLATION INSTRUCTIONS
Centerline & Ecoline Hot Door Type Tri Wash Arm Kit - 00-563658
NOTE: CDH model only.
These instructions are only intended for use by properly trained and qualified service technicians.
If you do not have technical training for this product, you should read the following procedure, in its entirety, to
determine if you have the necessary tools, instruments and skills required to perform the procedure. Procedures for
which you do not have the necessary tools, instruments and skills should be performed by a trained Hobart Service
technician.
The reproduction, transfer, sale or other use of this manual, without the express written consent of Hobart Service,
is prohibited.
Fig. 1
Mid-Tier Door Type Tri-Arm / Shaft Combo Kit - 00-563658
Item Part Number Description QTY
1 EW-308039 Plastic Arm Bushing 1
2 EW-325129 Shaft, Tri-Arm, Colged 1
3 EW-454007 Bushing Retaining Nut 1
4 EW-990164 Tri-Arm, Wash / Rinse, Colged 1
1. Place Loctite® 263 on shaft threads.
2. Place shaft in manifold.
NOTE: Allow a minimum of 6 hours to cure before reinstalling and using dishwasher. 24 hours is recommended.
© HOBART SERVICE 2022 Page 1 of 1 F45948 (October 2022)
/