IS-0066 Rev. B Page 1 of 2
OnQ
OnQ Technologies, Inc.
P.O. Box 60907
Harrisburg, PA 17106
Phone: 800-321-2343
Instruction/Installation Sheet
OnQ 4-Way Multi-Switch
IS-0066
Rev. B
364228-01
Figure 1
1. Introduction:
The OnQ 4-Way Multi-Switch is to be used with the OnQ CEBus Passive Video Module. The Multi-Switch is
for installation into the OnQ Tri-rail or Flat-rail Service Center Enclosures.
2. Description:
The OnQ 4-Way Multi-Switch allows Dual LNB and Cable to be delivered to 4 Receivers over a single cable.
3. Installation
A.
Mounting in enclosure – Refer to Figure 2.
1) Align tabs on assembly with slots on rail of enclosure.
2) Insert tabs by angling assembly away from the back of the enclosure and sliding forward.
3) Rotate the assembly and insert fasteners on assembly into corresponding holes on rail of
enclosure. (Plunger must be in the pulled out position for fastener to engage hole.)
4) Push plunger in to lock module in place. Pull on assembly to assure assembly is locked
properly in place.
Figure 2.
IS-0066 Rev. B Page 2 of 2
3. Service Connection – See Figure 3 and Figure 4.
1) Identify incoming service cable and route to “Cable In” fitting on splitter.
2) Connect a jumper cable to “Cable In” of video module and route cable to “Output” of splitter.
3) Connect a jumper cable to “Output” on splitter and route cable to “Antenna” input of Multi-Switch.
4) Identify incoming DSS cables and connect to “LNC-A” and “LNC-B” of the Multi-Switch.
5) Identify Outlet Cables that require DSS signals. Connect to “Receiver” Outputs on Multi-Switch.
6) Connect Outlet Cables that do not require DSS signals to Video Module.
7) Connect Power to “DC IN (20V)”. Route a jumper cable from “DC IN” to power module location.
Figure 3
Figure 4.
Disclaimer
OnQ recommends using RG-6 quad shielded solid copper cable in lieu of copper clad steel, especially with
applications that involve distributing DC voltages. Solid copper offers less DC resistance than copper clad steel and
thus less of a voltage drop. Many manufactures of 3
rd
party devices such as satellite receivers’ state NOT to use
copper clad steel for this reason. Use of copper clad steel could result in
voltage drop significant enough to
interfere with a DC voltage dependant device’s operation. As in any RF or RF/DC application, try to avoid excessively
long runs.
Cable & DSS
To Outlets
Cable In
DSS From
Dish
Cable To Outlets
DSS Distribution- Multi-Switch Module
CEBus
Passive
Module
Jumper
DC IN
DSS - Multi-Switch Application
34
34
34
34
DC IN
-
1
-
2
Legrand DBS 4 Way Multiswitch, IS-0066 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Legrand 12 Port Video Interface Module, IS-0191 Installation guide
-
-
-
-
-
-
-
-
-
