Legrand 1x16 Passive Video Module, IS-0179 Installation guide
- Category
- Signal cables
- Type
- Installation guide
Installation/Instruction Sheet
1x16 Passive Video
Module
IS-0179 Rev O
OnQ Technologies, Inc.
P.O. Box 60907
Harrisburg, PA 17106-0907
800-321-2343
www.onqtech.com
1. Introduction
The OnQ 1x16 Passive Video Module, P/N 364521-01, provides management and distribution of RF (Cable
TV)/off air signals on coaxial cable throughout the house. The 1x16 Video Module is a passive bi-directional
module and can be used to combine or distribute signals. The module can be used in conjunction with the
OnQ 16dB Video engine, P/N 364523-01, for balanced signal
distribution. The modules can be mounted in to any OnQ standard
Service Center Enclosure.
Figure 1
2. Description:
The 1x16 Video Module has “F”-style fittings for connecting
incoming and outgoing cables. The module is a half wide 9-inch tall
module. Overall module dimensions are 6.42 (W) x 9.00 (L) x 3.50
(H). The 1x16 Video Module has 1 input with 16 outputs (see
Figure 1).
3. Installation:
A. Mounting in enclosure (see Figure 2)
Figure 2
1. Align tabs on module with slots on rail of enclosure.
2. Insert tabs by angling module away from the back of the
enclosure and sliding forward.
3. Rotate the module and insert fasteners on module into
corresponding holes on rail of enclosure. (Plunger must
be in the pulled out position for fastener to engage hole.)
4. Push plunger in to lock module in place. Pull on module to
assure module is locked properly in place.
Note: Do Not
bend cable in less than a 2 inch radius.
B. Service Connection
1. Identify incoming service cable(s) and route to “Cable In” on module.
2. Attach an RG-6 “F”-connector to the cable. Connect to fitting on module and finger-tighten.
C. Outlet Drop Connections
1. Identify cables from the outlets and route to appropriate fittings.
2. Attach an RG-6 “F”-connector to the cable. Connect to fitting on module and finger-tighten.
Note: Cables should all be marked to provide identification. Record room locations for
cables to the outlets.
IS-0179 Rev. O Page 1 of 1
-
1
Legrand 1x16 Passive Video Module, IS-0179 Installation guide
- Category
- Signal cables
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Legrand 12 Port Video Interface Module, IS-0191 Installation guide
-
-
-
-
-
-
-
-
-
