5019 318 33114
AKR 683 - AKR 633
INSTALLATIONSANGABEN
Mindestabstand zur Kochfläche: 43 cm (Elektrokochplatten), 65 cm (Gas-,
Öl- oder Kohlekochplatten). Folgen Sie bei der Installation der
Nummerierung (1
Ö
2
Ö
3
Ö
.....). Schließen Sie das Gerät erst nach erfolgter
Installation an die Stromversorgung an. Das Auslassrohr (18) wird nicht
mitgeliefert und muss gesondert erworben werden. Frontblenden mit
Einbauanleitung sind in verschiedenen Farben erhältlich.
INSTALLATION SHEET
Minimum height above cooker: 43 cm (electric cookers), 65 cm (gas, gas oil
or coal cookers). To install, follow points (1
Ö
2
Ö
3
Ö
.....). Do not connect the
appliance to the electrical power supply until installation is completed. The
exhaust pipe (18) is not supplied, and should be bought separately. The front
panels are ready to mount and available in various colours and should be
bought separately.
FICHE D'INSTALLATION
Distance minimale par rapport à la cuisinière : 43 cm (cuisinière électrique),
65 cm (cuisinière à gaz, mazout ou charbon). Pour le montage, suivez la
numérotation (1
Ö
2
Ö
3
Ö
.....). Ne branchez pas l'appareil tant que
l'installation n'est pas terminée. Le tuyau d'évacuation (18) n'est pas fourni
avec l'appareil et doit être acheté. Des façades dans différents coloris et déjà
prêtes à être installer sont disponibles.
INSTALLATIEKAART
Minimumafstand tot het kooktoestel: 43 cm (elektrische kooktoestellen),
65 cm (kookstellen op gas, olie of kolen). Volg voor de montage de
nummering (1
Ö
2
Ö
3
Ö
.....). Geef het apparaat geen stroom totdat de
installatie geheel voltooid is. De afvoerleiding (18) wordt niet bijgeleverd en
moet apart aangeschaft worden. U kunt kant-en-klare frontstukken in
verschillende kleuren bestellen.
D
GB
F
NL
31833114.fm Page 1 Tuesday, December 9, 2003 6:33 PM
5019 318 33114
AKR 683 - AKR 633
FICHA DE INSTALACIÓN
Distancia mínima desde los quemadores: 43 cm (quemadores eléctricos),
65 cm (quemadores de gas, gasóleo o carbón). Para el montaje, siga la
numeración (1
Ö
2
Ö
3
Ö
...). No conecte el aparato a la corriente eléctrica
hasta que la instalación esté completamente finalizada. El tubo de salida (18)
no se suministra con la campana y debe comprarse aparte. Están disponibles
frontales de distintos colores preparados para su instalación, que es necesario
pedir.
FICHA DE INSTALAÇÃO
Distância mínima dos fogões: 43 cm (fogões eléctricos), 65 cm (fogões a gás,
óleo ou carbono). Para a montagem siga a numeração (1
Ö
2
Ö
3
Ö
.....). Não
ligue o aparelho à corrente eléctrica até a instalação estar concluída. O tubo
de descarga (18) não é fornecido e deve ser adquirido. Estão disponíveis,
mediante encomenda, partes frontais em várias cores, já prontas para serem
instaladas.
SCHEDA INSTALLAZIONE
Distanza minima dai fuochi: 43 cm (fuochi elettrici), 65 cm (fuochi a gas,
gasolio o carbone). Per il montaggio seguire la numerazione (1
Ö
2
Ö
3
Ö
.....).
Non dare corrente all’apparecchio finché l’installazione non è totalmente
completata. Tubo di scarico (18) non è fornito e va acquistato. Sono
disponibili, da ordinare, frontali già pronti per l'installazione in vari colori.
ùüùü+ùùùþ
ü$12.)12.1.)2"0120" FP02!"0120" FP
0120".0! #02!0. #0! # +.22 21
. #1202.!1
1
Ö
2
Ö
3
Ö
2! 3 / 20200
02!)!0*.21#10 #!2 !&12"0.212.1"
1&."..&"/0/.202.02 . !! 32!..
!0.. 20$&!12û.202...!.0.! 1)%0"
2 0".0.212.110/3 !.$!+.2.
E
P
I
*5
31833114.fm Page 2 Tuesday, December 9, 2003 6:33 PM
5019 318 33114
AKR 683 - AKR 633
31833114.fm Page 3 Tuesday, December 9, 2003 6:33 PM
5019 318 33114
AKR 683 - AKR 633
D F NL E
GB
P I GR
1.
Control panel.
2.
Extractor grilles with internal grease
filters - External grease filters
(models DNHV5460 and DNV5460 only).
3.
Lighting unit.
4.
Pull-out steam deflector (switches the hood on/off
if an extraction speed has already been selected).
Replacing bulbs:
1.
Disconnect the electrical power supply.
2.
Pull out the steam deflector.
3.
Open the back grille (
a - fig. 1
).
4.
Remove the burnt-out bulb.
Replace using 40 W max E14 bulbs only.
5.
Refit the extractor grille or lighting unit.
Removing and renewing or cleaning the grease
filter:
1.
Disconnect the electrical power supply.
2.
Pull out the steam deflector.
3.
Remove the extractor grilles (
c - fig. 1 / d - fig. 2
).
4.
Release the grease filter.
5.
Remove the dirty grease filter (
e - fig. 2
).
6.
After the grease filter has been renewed or
cleaned (depending on model), remount in
reverse order, making sure the entire extraction
surface is covered.
Fitting or renewing the carbon filter:
1.
Disconnect the electrical power supply.
2.
Pull out the steam deflector.
3.
Remove the extractor grilles (
c - fig. 1 / d - fig. 2
).
4.
If the carbon filter (
f - fig. 3
) is already fitted and
needs renewing, turn anti-clockwise and pull the
filter out downwards.
5.
If the carbon filter (
f - fig. 3
) is not already fitted,
mount the filter over the protection grille and turn
clockwise.
6.
Refit the extractor grille.
CONTROL PANEL
Light switch.
The switch has two positions
(lights OFF - lights ON).
To switch on the lights: move the switch to the
right.
Motor switch.
The extraction speed switch has 3 settings,
depending on the amount of steam and fumes.
To increase the extraction speed: move the
switch to the right.
Fig. 1
Fig. 2
Fig. 3
f
PRODUCT SHEET
31833114.fm Page 6 Tuesday, December 9, 2003 6:33 PM
/