Installation Guide
Case components
C50.Q2600.00E
Remove side panels Motherboard installation
Place the M/B onto the copper bolt
and fasten screws to secure.
Hardware list
Dual LED
Power switch
(Blue LED for power)
(Red LED for HDD)
Multi-media ports
120 mm fan
Ventilation holes
in the PCI slots
Female clip
2.5" HDD mount
120 mm fans x 3
Removable
PSU bracket
3.5" HDD cage
for 3.5" HDD x 10
(Hot swap x 2)
Pull side panel out to
remove.
Extra quantities are spare parts.
Clamp (2)
Buzzer (1)
Cable ties (1)
Screws (5)
for M/B
Screws (5)
for PSU mounting
Screws M3*9.5 (5)
for 2.5" HDD
Anti-vibration rubber rings (5)
for 2.5" HDD / 3.5" HDD
Anti-vibration silica gel rings (44)
for 3.5" HDD
Thumb screws (44)
for 3.5" HDD
Install screws along with
anti-vibration rubber rings
onto the HDD.
2.5" HDD installation
3.5" HDD installation-1 (hot swap)
Close the gate to secure
the HDD.
Slide the HDD into the
HDD cage.
Install screws along with
anti-vibration silica gel rings
onto the 3.5" HDD.
Slide the HDD into the
holes on the HDD platform.
I/O port installation
HD AUDIO
BLUE
BLACK PURPLE
YELLOW
GRAY
RED
10
8
6
4
2
9
7
5
3
1
GREEN
KEY
ORANGE
N.C.
GND+H.S. TUBE
11
20
10
1
USB 3.0
Supports motherboard
USB 3.0 20 Pin header
Cable guideinstallation
POWER SW
BLACK / WHITE
BLACK
POWER LED
POWER LED
BLACK -
BLACK / WHITE +
HDD LED
BLACK / WHITE -
BLACK +
SPEAKER
RED+
NC
NC
Blue
PSU installation
Loose 4 thumb screws to
remove the PSU
mounting bracket.
Push in gently.Assembly power supply with
PSU mounting bracket.
Fasten 4 thumb screws
to secure.
Removing fan modules
Slide the anti-vibration fan sideways to remove.
Cable management
Press to release.
Remove air filters
Reserved hole for
fan
(Fan is not included)
installation 120 mm
Removable
air filter