Anova F2030 Assembly Instruction

Brand: Anova

Model: F2030

Type: Assembly Instruction

Assembly Instructions

anovafurnishings.com

800.231.1327 tel

Component parts:

Hardware Needed:

Assembly:

1. Inspect the shipping container contents for damaged or missing components.

2. Lay all parts on a soft work surface or on the shipping packaging to prevent damage to nish.

NOTE: Before assembly, it is recommended that a light oil or petroleum jelly be applied to screw threads.

Tools Needed:

• 3/4” Hex Wrench

• 3/4 Hex Socket with Ratchet

• Retractable Measuring Tape

• Pencil

F2030 - 2-1/2’ Expanded Steel Bench, Portable

2-1/2’ Expanded Steel Bench, Portable

Cross Brace Seat Legs

Hex Head Bolt

5/16” x 1-1/4” Stainless

Steel

Nylock Nut

5/16”-18

316 SS

Flat Washer

5/16”

Stainless Steel

Rubber FootHex Head Bolt

5/16” x 3”

Stainless Steel

Assembly Instructions

2-1/2’ Expanded Steel Bench, Portable

3. Locate the leg and two rubber feet and place them

as shown.

4. Insert the two rubber feet into the bottom of the

leg. Use a rubber mallet if necessary.

5. Repeat steps 3 and 4 with the remaining leg and

rubber feet.

6. Mount a leg to the bench seat by inserting two

1-1/4” hex head bolts and two at washers through

the mounting holes of the bench seat and the leg.

Place a washer and nylock nut on each bolt and

tighten nger tight.

Repeat this step to attach the remaining leg.

Assembly Instructions

2-1/2’ Expanded Steel Bench, Portable

• Furniture must not be used other than for its intended purpose and should be inspected regularly for loose, missing, or

broken hardware, and general instability

• Furniture that is damaged or appears to be unstable must be removed from service and repaired or replaced

• Repairs must be made using only factory authorized parts and methods.

WARNING

• Do not drag the assembled unit across any surface.

• This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to remove surface

dirt. Do not clean with a solvent or petroleum based products.

CARE AND

MAINTENANCE

Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.

7. Mount a cross brace to a leg by inserting one

3” hex head bolt and a at washer through the

mounting holes. Place a at washer and nylock nut

on the end of the bolt and tighten nger tight.

Repeat this step to mount the remaining cross

braces on the other leg.

a. Align the cross brace with the mounting

hole on the bench. Insert one 1-1/4” hex

head bolt and a at washer through the

mounting hole. Place a at washer and

nylock nut on the end of the bolt and

tighten nger tight.

8. Turn the bench upright and move it to desired

location.

Replacement Parts

Bench

Leg

Cross

Brace

Anova F2030 Assembly Instruction

Anova F2030 Assembly Instruction

Anova F2030 Assembly Instruction

Related papers

Other documents