2. Honda
  3. CASSETTE/MP3 PLAYER

Honda CASSETTE/MP3 PLAYER, 08A06-4E1-201 Installation Instructions Manual

  • Hello! I am an AI chatbot trained to assist you with the Honda CASSETTE/MP3 PLAYER Installation Instructions Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
© 2005 American Honda Motor Co., Inc. - All Rights Reserved. All 30488 (0509) 1 of 6
PRELIMINARY
08B06-S9V-1B00-91
INSTALLATION
INSTRUCTIONS
Accessory Application Publications No.
Issue Date
SEP 2005
2006 PILOT
CASSETTE/MP3 PLAYER
(EX)
Player Attachment Kit (sold separately) :
P/N 08B06-S9V-100A
3 Wire ties
3 EPT sealer
BUS cable
DIN Bezel Kit (sold separately) :
P/N 08B23-S9V-100C
Left player bracket
Right player bracket
DIN bezel
Cassette Player (sold separately) :
P/N 08A03-5E1-001
Cassette player
4 Washer-screws, 5 x 8 mm
Owner’s manual
MP3 Player (sold separately) :
P/N 08A06-4E1-201
MP3 player
4 Washer-bolts, 5 x 8 mm
Owner’s manual
All 30488
2 of 6 All 30488 (0509) © 2005 American Honda Motor Co., Inc. - All Rights Reserved.
PRELIMINARY
5601020
Y
5412041
B
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
10 mm Combination wrench
Ratchet
10 mm Socket
ILLUSTRATION OF THE COMPONENTS ON
THE CAR
METER PANEL
SELF-TAPPING
SCREW
CLIPS (2)
4. Remove the meter sub panel (three clips).
CLIPS (3)
METER SUB
PANEL
AUDIO PANEL
5804570
Y
AUDIO UNIT
BUS
CABLE
CASSETTE
PLAYER
5804580
Y
AUDIO UNIT
MP3
PLAYER
BUS
CABLE
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by “do-it-yourselfers”.
1. Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2. Disconnect the negative cable from the battery.
3. Remove the meter panel (two self-tapping screws
and two clips).
© 2005 American Honda Motor Co., Inc. - All Rights Reserved. All 30488 (0509) 3 of 6
PRELIMINARY
5727401
Y
5412051
B
VEHICLE
CONNECTOR
CLIPS (5)
AUDIO PANEL
5. Gently pull out on the left side of the audio panel
to release the two clips, then pull out to release
the remaining three clips. Unplug the vehicle
connectors and remove the audio panel.
6. Remove the audio unit (four screws, pull the audio
unit out toward you, unplug the vehicle connectors
and antenna lead).
DRIVER’S CENTER
CONSOLE TRIM PASSENGER’S CENTER
CONSOLE TRIM
CLIPS (3)
7. Remove the driver’s and passenger’s center
console trim pieces (three clips each). Take care
not to damage the clips.
AUDIO
BRACKET
SCREW
(Reuse.)
VEHICLE 14-PIN
CONNECTOR
(2WD vehicle only.)
VEHICLE 20-PIN
CONNECTOR
AUDIO
BRACKET
ANTENNA
LEAD
SELF-TAPPING
SCREW
CENTER PANEL
CLIPS (2)
VEHICLE
CONNECTOR
8. Remove four self-tapping screws that fasten the
center panel.
9. Pull the center panel out toward you to release
the two clips. Unplug the vehicle connector from
the accessory socket, and remove the center
panel.
4 of 6 All 30488 (0509) © 2005 American Honda Motor Co., Inc. - All Rights Reserved.
PRELIMINARY
5715030
Y
SELF-TAPPING SCREW
(Removed in step 11.)
5 x 8 mm
WASHER
SCREW
(Included
with the
player.)
5 x 8 mm
WASHER
SCREW
(Included with
the player.)
HEATER
CONTROL
UNIT
DIN BEZEL
SELF-
TAPPING
SCREW
LEFT VEHICLE
BRACKET
(Not reused.)
HEATER
CONTROL UNIT
POCKET RIGHT
VEHICLE
BRACKET
(Not reused.)
SELF-
TAPPING
SCREW
SELF-
TAPPING
SCREW
(reuse.)
SELF-
TAPPING
SCREW
(reuse.)
SELF-
TAPPING
SCREW
(Removed
in step 11.)
RIGHT
PLAYER
BRACKET
LEFT PLAYER
BRACKET
PLAYER
5426240
Y
BUS
CABLE
VEHICLE
HARNESS
WIRE TIE
BUS CABLE
14-PIN
CONNECTOR
TO AUDIO UNIT
AUDIO
PANEL
OPENING
HEATER
CONTROL
UNIT
OPENING
30 mm
11. Remove the left and right vehicle brackets (six
self-tapping screws), and separate the heater
control unit from pocket. Set the pocket aside, it
will not be reused.
12. Install the DIN bezel to the player. Set the heater
control unit on the player, and attach the left and
right player brackets to the player and the heater
control unit using the two self-tapping screws
removed in step 11 and four 5 x 8 mm washer-
screws included with the player.
Installing the Player
13. Route the bus cable from the audio panel opening
to the heater control unit opening. Using one wire
tie, secure the bus cable to the vehicle harness.
RIGHT
VEHICLE
BRACKET
SCREW
HEATER
CONTROL UNIT
POCKET
LEFT
VEHICLE
BRACKET
VEHICLE 30-PIN
CONNECTOR
VEHICLE 20-PIN
CONNECTOR
10. Remove four screws that fasten the left and right
vehicle brackets. Pull the heater control unit and
pocket out toward you, and unplug the vehicle
connectors.
© 2005 American Honda Motor Co., Inc. - All Rights Reserved. All 30488 (0509) 5 of 6
PRELIMINARY
5426250
Y
BUS CABLE
AUDIO UNIT
BUS CABLE
14-PIN
CONNECTOR
5426131
Y
5426260
AUDIO UNIT
AUDIO
BRACKET
AUDIO
BRACKET
SCREW
(Reuse.)
ANTENNA
CONNECTOR
VEHICLE
HARNESS
BUS
CABLE
BUS
CABLE
WIRE TIE
EPT
SEALER
AIR
DUCT
HEATER
CONTROL
UNIT
OPENING
VEHICLE 30-PIN
CONNECTOR
VEHICLE 20-PIN
CONNECTOR
VEHICLE 20-PIN
CONNECTOR
VEHICLE 14-PIN
CONNECTOR
(2WD vehicle Only.)
15. Connect the two vehicle connectors and the
antenna connector to the audio unit. Insert the
audio unit into the audio panel opening and
secure it with the four screws that you removed in
step 6.
14. Connect the bus cable 14-pin connector to the
audio unit.
16. At the heater control unit opening, attach two EPT
sealers to the bus cable at the location shown.
17. Secure the bus cable to the vehicle harness using
one wire tie.
6 of 6 All 30488 (0509) © 2005 American Honda Motor Co., Inc. - All Rights Reserved.
PRELIMINARY
5426161
Y
RIGHT
PLAYER
BRACKET
SCREW
(reused.)
HEATER
CONTROL
UNIT
LEFT
PLAYER
BRACKET
BUS
CABLE
VEHICLE 30-PIN
CONNECTOR
WASHER-
SCREW
(reused.)
WASHER-
SCREW
(reused.)
VEHICLE 20-PIN
CONNECTOR
19. Remove the two washer-screws from the
dashboard.
20. Connect the vehicle connectors to the heater
control unit, and reinstall the heater control unit
using the four screws you removed in step 10.
21. Check that all wire harnesses are routed properly
and all connectors are plugged in.
22. Reconnect the negative cable to the battery.
23. Enter the customer’s radio anti-theft code, and
reset the radio station presets.
24. Set the clock.
25. Check the operation of the player according to the
owner’s manual supplied with the player.
26. Put the player Owner’s Manual in the glove box.
27. Reinstall all removed parts.
NOTE : Whenever the battery is disconnected, the
driver’s AUTO function is disabled.
28. Start the engine. Push down on the driver’s
window switch until the window is fully open.
29. Pull up on the driver’s window switch to close the
window completely, then hold the switch for 2
seconds or more.
30. Test the AUTO window function.
5426150
Y
5426140
Y
BUS CABLE
14-PIN
CONNECTOR
BUS CABLE
CASSETTE
PLAYER
BUS CABLE
14-PIN
CONNECTOR
BUS CABLE
MP3
PLAYER
HEATER
CONTROL UNIT
HEATER
CONTROL UNIT
18. Connect the bus cable 14-pin connector to the
player.
Cassette player
MP3 player
/