2. Computers & electronics
  3. TVs & monitors
  4. Video splitters
  5. AVPro Edge
  6. AC-EX150-HD-C9R*

AVPro Edge AC-EX150-HD-C9R* Quick Start

  • Hello! I've reviewed the Quick Start Guide for the AVPro Edge AC-EX150-HD-C9R HDBaseT receiver. This guide provides instructions for setting up the receiver, which includes connecting three cables, and also troubleshooting steps. I'm here to answer any questions you might have about the device or its setup.
  • How many connections are needed to setup the receiver?
    What kind of cable is needed to connect the Cloud 9 to the receiver?
    What should I do if the power indicator light is not on?
    What do I do if the unit is not working and I have checked the connections?
Uncompressed 1080P signal, 150m receiver
AC-EX150-HD-C9R
Quick Start Guide
Built specically for the Cloud 9, this 150 meter HDBaseT receiver
can extend an uncompressed 1080p video signal up to 150 meters over
a single CAT 6a/7. Because of its slim
design, this receiver can be mounted
virtually anywhere!
This quick start guide will be
going through:
• Set up of the Receiver
• Troubleshooting
Setup of the Receiver:
Installation is simple! Only 3 connections need to be made
1) a Category cable needs to be plugged from the Cloud 9 to the HDBT port on
the receiver
2) a short HDMI cable from the HDMI output to the display
3) power supply plugged into the 48V power connector on the receiver
48V power
connector
power Indicator
3.5mm RS232
HDBT HDMI
Out
IR OUT IR IN HDMI status light
Troubleshooting
Verify Power- A power indicator light will apear if the receiver
is getting power
Verify Connections - Check that all cables are properly
connected
If you are still having issues after troubleshooting, feel free to
contact our Tech Support department.
Have a question or need assistance?
Don’t hesitate to contact us!
SUPPORT: +1 605-274-6055
USA TOLL FREE: 877-886-5112
EMAIL: support@avproedge.com
/