5019 100 75044
DFG 3360 - 3390,
D 720 / DFO 3060
PRODUCT DESCRIPTION SHEET
1.
Control panel.
2.
Grease filters (inside the extractor grille).
3.
Lighting unit.
4.
Pull-out steam deflector.
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector (
a
).
3.
Open the extraction grille (
b
,
c
,
d
).
4.
Remove the device fixing the grease filter (
e
).
5.
Remove the dirty grease filter.
6.
After renewing or cleaning the grease filter
(depending on model) repeat the above
steps in reverse to reassemble, making sure
the entire extraction surface is covered.
RENEWING BULBS
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector (
a
).
3.
Open the extraction grille (
b
,
c
,
d
).
4.
Remove the burnt-out bulb and insert
a new one.
Use only 40W max E14 bulbs.
5.
Remount the extractor grille.
MOUNTING OR RENEWING THE
CARBON FILTER
(except for model
DFO 3060
)
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector (
a
).
3.
Open the extraction grille (
b
,
c
,
d
).
4. Mounting:
Fit the filter over the motor
protection grille within the reference
marks (
f
). Line up the reference mark (
g
)
on the edge of the carbon filter with the arrow
on the fan shroud (
h
). Then turn clockwise.
Removal:
turn anticlockwise.
5.
Remount the extractor grille.
CONTROL PANEL
A.
Light switch.
B.
Speed selector (except for model
DFO 3060
).
C.
Extraction speed indicators.
D.
Valve opening/closing switch
(only
DFO 3060
).
a
d
b
c
1
4
3
2
e
e
D 720
0123 0 I
0123 0I
01
0I
small amount
of steam and
fumes
large amount of
steam and fumes
AB
medium amount of
steam and fumes
BAC
Model
DFO 3060
must be connected to an
external extraction unit. Open the valve to
allow extraction of steam and fumes.
DA
DFG 3360
DFG 3390
f
f
f
f
f
g
h
g
f
h
F NL E PGBD GRI
