V-ZUG 286 Installation guide

Type
Installation guide

This manual is also suitable for

V-ZUG 286 is a condenser tumble dryer designed for one-family households. It offers a range of features to make drying clothes convenient and efficient. With a total connected load of max. 6900 W, it can handle large loads of laundry quickly. The appliance also boasts a variety of programs, including a 20-minute refresh cycle for lightly used items. Additionally, the V-ZUG 286 is equipped with a condensate drain hose for easy disposal of excess moisture.

V-ZUG 286 is a condenser tumble dryer designed for one-family households. It offers a range of features to make drying clothes convenient and efficient. With a total connected load of max. 6900 W, it can handle large loads of laundry quickly. The appliance also boasts a variety of programs, including a 20-minute refresh cycle for lightly used items. Additionally, the V-ZUG 286 is equipped with a condensate drain hose for easy disposal of excess moisture.

Installation instructions
Condenser tumble dryer
One-family household
J284.114-2
24.6.08 ITH
1
These installation instructions apply to the models: 284, 286
A Information on the necessary mains voltage, type of current and fuse protection is to be obtained from the identification plate.
Connection cable
Combined connection with washing machine 250–258, 267
The room must be well ventilated to ensure that the room temperature does not exceed 30 °C.
Small enclosed storage rooms, bathrooms, WCs, showers etc. with no ventilation are not suitable locations for this tumble dryer.
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
Validity
Electrical connections
Electrical connections must be carried out by trained electricians in accordance with the guidelines and standards for low volt-
age installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. A
mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and socket
devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching are per-
missible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and fault-
free operation. After installation, live parts and cables with basic insulation must not be accessible. Old installations should al-
ways be checked.
400 V 2N~ 50 Hz, 10 A 230 V~ 50 Hz, 10 A 230 V~ 50 Hz, 16 A
Colour code
L2
L1
black
brown
blue
yellow/green
Room conditions / ventilation
Do not obstruct the appliance’s ventilation slits to ensure that there is an ample supply of air.
Openings of min. 400 cm²: to the washing room: Open window. Ventilation grille or slits in the door or a ventilation system.
to the fitted niche: Opening to the next compartment or ventilation grille.
N
L2
L1
4 × 1 mm
2
3 × 1 mm
2
N
L1
N
L1
3 × 1.5 mm
2
N
1
0
L1
L2
L3
N
10 A
Total connected load: max. 6900 W
Washing machine
Tumble dryer
Wall switch
Mains
400 V 3N~
brown
black
brown
blue
yellow/green
4 × 1 mm
2
(3 × 1 mm
2
)
Mains cable
Installation instructions
Condenser tumble dryer
One-family household
J284.114-2
24.6.08 ITH
2
1. Raise the appliance slightly at the front and pull it forward, away
from the installation plate.
2. Secure the installation plate to the location you wish to install the
appliance using 4 screws. On smooth and clean floors, affix the
installation plate with the enclosed double-sided adhesive tape.
3. Dampen the mounting slots on the installation plate with water.
4. To ensure smooth, fault-free operation, the appliance must be
perfectly vertical. Use a spirit level to position the appliance.
5. Slide the appliance into position and finely adjust the front adjuster
feet until the appliance is stable. The appliance must not wobble.
Free-standing position
Positioning in niche
A Center the installation plate in the niche.
* This only applies if no plumbing fittings are to be installed behind the appliance.
Installation
Use the installation plate to install the appliance. This plate fixes the appliance in position (for both free-standing appliances
and appliances placed in a niche).
If a tumble dryer and a washing machine are positioned side by side, keep a distance of min. 5 mm between installation plates
and min. 3 mm to walls.
min. 3
597
595
50
505
min. 550*
min. 5
min. 5
min. 600
Niche width
Niche height
min. 860 mm!
min. 600*
Niche depth
Cut-out for lateral
connections, to the
left or right side
min. 100 × 100 mm
Installation instructions
Condenser tumble dryer
One-family household
J284.114-2
24.6.08 ITH
3
Cannot be connected to a double drain trap.
There must be a separate concealed drain trap for each appliance.
Washer-dryer combination with W5.4917 combi drainage set
Washer-dryer tower
The pronto-combi connection can be used (installation set W5.0040).
A Operate (with no load) as explained in the operating instructions.
A Select the programme, 20 minutes.
Condensate drain
When installing the drainage hose, protect it against damage and bending! For that, use a hose clip 8.086.8039.
A Unscrew screw A.
A Remove cover B.
A Push the supplied drainage hose C
(2 m) through the hole in the cover B.
A Push on to the pump connection piece
and secure with a hose clip.
A Replace cover B.
The max. pumping height of the pump is 1.2 m Drain into fixed upright outflow pipe
Function control / operating for the first time
B
A
B
C
B
min. 800
Connection to
sink drain trap
min. 350
max. 700
min
min
  • Page 1 1
  • Page 2 2
  • Page 3 3

V-ZUG 286 Installation guide

Type
Installation guide
This manual is also suitable for

V-ZUG 286 is a condenser tumble dryer designed for one-family households. It offers a range of features to make drying clothes convenient and efficient. With a total connected load of max. 6900 W, it can handle large loads of laundry quickly. The appliance also boasts a variety of programs, including a 20-minute refresh cycle for lightly used items. Additionally, the V-ZUG 286 is equipped with a condensate drain hose for easy disposal of excess moisture.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI