Claoner Dash Cams for Cars Front and Rear FHD 1080P Dashcam, Dual Dash Cam User manual

Brand: Claoner

Model: Dash Cams for Cars Front and Rear FHD 1080P Dashcam, Dual Dash Cam

Category: Dashcam

Type: User manual

This manual is also suitable for

Dash Cam Car Camera Front and Rear FHD 1080P Dual Dash Cam Backup Car Camera

User Manual

CLAONER

Table of Contents

Warranty & Customer Support ..........................2

Product Specifications .......................................1

Package Contents ...............................................2

Camera Overview ................................................3

Getting Started ...................................................6

Video Settings ...................................................11

Device Layout .........................................................................3

Buttons ....................................................................................4

Installation ...............................................................................6

Charging the Battery ...............................................................8

Inserting the Memory Card ......................................................9

Removing the Memory Card ...................................................9

Formatting the Memory Card ................................................10

Powering the Device Manually ..............................................10

Basic Operation .....................................................................11

Resolution ..............................................................................11

Loop Recording .....................................................................12

HDR (High Dynamic Range) .................................................13

Exposure ...............................................................................12

Record Audio .........................................................................12

Date Stamp ...........................................................................13

Gravity Sensing .....................................................................13

System Settings ................................................14

Photo Settings ..................................................16

Parking Monitor .....................................................................14

Date/Time ..............................................................................14

Auto Power Off ......................................................................14

Beep Sound ..........................................................................15

Language ..............................................................................15

Frequency .............................................................................15

Format ...................................................................................15

Screen Saver ........................................................................14

Default Setting .......................................................................15

Version ..................................................................................15

Resolution .............................................................................16

Sequence ..............................................................................16

Sharpness .............................................................................16

Quality ...................................................................................16

White Balance .......................................................................16

ISO ........................................................................................17

Exposure ...............................................................................17

Anti-Shaking ..........................................................................17

Quick Review ........................................................................17

Date Stamp ...........................................................................17

Playback ............................................................18

Product Care .................................................... 20

Questions & Answers ...................................... 20

Camera Playback Mode ........................................................18

Computer Playback ...............................................................19

Product Specifications

Lens 6-layer fixed-focus with full-glass elements

CPU GC2023

Display 3.0 inch IPS LCD

Audio I/O Internal high-sensitivity mic and speaker

External Memory Class 10 or higher Micro SD card (up to 32GB)

Gravity Sensor Low / Medium / High / Off

Shutter Electronic

Frequency 50HZ / 60HZ

Exposure

+2/3+1/3+0.0-1/3

Battery 180mAh 3.7V rechargeable lithium-ion battery

Video Format .MOV

USB Connection USB 2.0

Loop Recording 1 min / 2 min / 3 min / 5 min/ Off

Screen Saver 3 min / 5 min / 10 min / Off

Auto Power Off 1 min / 3 min / Off

Audio Recording 1 min / 3 min / Off

Video Resolution 1080FHD 1920x1080, 1080P 1440x1080,

720P 1280x720

Languages English, Chinese, French, Spanish, Portuguese,

German, Italian, Russian, Japanese

Package Contents

Warranty & Customer Support

The following items should be found in the package:

1*CLAONER D2 Dashboard Camera

1*Car charger

1*3M adhesive mount

1*Suction cup mount

1*USB cable

1*User manual

1*Thank you card

For questions, support, or warranty claims, please contact

us at the address below.

Customer Service Team : Support@claoner.com

Camera Overview

Device Layout

1. Micro SD Card Slot

2. UP

3. MENU

5. OK

4. DOWN

6. MODE

7. Emergency Lock

8. POWER

9. Mini-USB Port

10. Bracket mounted hole

11. Rear Camera Hole

9 10 11

Buttons

Button Function

Hold to turn the device on or off manually

Cycle through menus or exit current menu

Toggle between Video / Photo / Playback modes

Playback Mode: Stop playback

Toggle display on/off

Menus: Confirm a selection

Video Mode: Manually lock current recording

Photo Mode: Take photo

Playback Mode: Play/pause recording

Menus: Move selection up

Video Mode: Start/stop recording

Photo Mode: Zoom in

Playback Mode: Decrease or reverse playback

speed / Cycle left through recordings

Menus: Move selection down

Video Mode: Enable/disable audio recording

Photo Mode: Zoom out

Playback Mode: Increase playback speed /

Cycle right through recordings

Status Icons

Icon Meaning

Video Resolution

Blinking – Recording

High Dynamic Range enabled

Connected to power source

Battery level (not connected to power source)

Audio recording disabled

Audio recording enabled

Video Recording Mode

Playback Mode

Photo Mode

Loop Recording

Memory card detected

G-sensor sensitivity

White Balance

Motion Detection

Getting Started

Installation

1.Attach the camera to the window mount

Make sure that you mount the camera in a safe, appropriate location

where it will not obstruct the driver’s view. Clean your windshield before

applying the mount.

2.Mounting the rear camera

Mount the rear camera as shown below, using rear camera extension

cable, connect rear camera to the main unit. The red wire is connected to

the positive lead of reversing lights, thus the dash cam will act as backup

camera when reversing.

3.Insert a memory card

You will need to insert a memory card before you can begin recording.

Do not insert or remove a memory card while the device is powered on.

The CLAONER D2 supports Micro SD cards up to 32GB in size.

4.Connect the car charger to the car's 12V~24V DC outlet

Run the cable down from your camera to the 12V~24V cigarette lighter

port of your vehicle, as shown in the diagram.

5.Format the memory card

To ensure your camera records to your Micro SD card properly and without

error,

you must format the card within the camera.

Charging the Battery

Connect your camera to your vehicle via the included car charging cable to

power your camera and charge the battery while driving.

Connect the charger to the car cigarette lighter or 12V~24V DC power outlet,

then insert the mini-USB end of the charger into the mini-USB port on the

camera.

You should always connect the camera to a power source while recording.

The internal battery is primarily used to save files in the event of an

emergency and is only intended to handle a maximum of 15 minutes of

disconnected operation.

If the battery is completely depleted, the device will not turn on

immediately when the charger is connected. Allow a depleted battery to

charge for at least 5 minutes before attempting to turn on the device.

If the device receives an unstable power supply while charging,

the screen may not function properly. If this happens, unplug the charger

from the device.

While charging, the device may heat up. This is normal and should

not affect the device’s performance or lifespan.

If the device is not charging properly, take the device and the charger

to an authorized CLAONER Service Center or contact Customer Care.

Connecting the charger improperly may cause serious damage to

the device. Any damage caused by misuse is not covered by the

warranty.

Use only CLAONER-approved chargers. Using unapproved chargers

or cables can damage the device or cause the battery to explode.

Inserting the Memory Card

Removing the Memory Card

The D2 accepts Micro SD memory cards (class 10 or higher) with a

maximum capacity of 32GB. Depending on the memory card manufacturer

and type, some cards may not be compatible with your device.

Using an incompatible card may damage the device or the memory

card, or corrupt the data stored on it.

Inserting a memory card:

1.Press and hold the Power button to turn the camera off.

2.Insert the card in the orientation shown.

3.Push the card into the slot.

4.Listen for click sound that signals the card is securely inserted.

Before removing a memory card from your camera, you must first prepare

it for safe removal by powering down the device.

Removing a memory card from your camera:

1.Press and hold the Power button to turn the camera off.

2.Gently push the memory card in until you hear a click, and allow the

spring release to push the card out.

Formatting the Memory Card

Powering the Device Manually

Do not remove the memory card while the device is transferring or

accessing information. Doing so can result in data loss or corruption,

or damage to the memory card or device. CLAONER is not responsible

for losses that result from the use of damaged memory cards,

including the loss of data.

Using your camera to format a memory card:

1.Upon turning on the camera, press the OK button to stop recording.

2.Press the Menu button twice to enter the Setup Menu.

3.Use the up and down buttons to navigate to the "Format" option.

4.Press OK to confirm your selection.

5.You will be notified that all data will be deleted. Press the down button

to scroll down to “OK”.

6.Press OK to confirm.

Before formatting your memory card, always remember to make

backup copies of all important data stored on the device. The

manufacturer’s warranty does not cover loss of data resulting

from user actions.

It’s recommended that you format your memory card after

transferring files to your computer, or at least once a month.

For best results, format the memory card using the Format

function on your camera.

You may find yourself wanting to access the device manually,

independent from a power source. To do so, press and hold the Power

button for a few seconds to manually turn on the device. A welcome

message will be displayed onscreen, as shown in the image below.

To turn off the device, again press and hold the Power button for a few

seconds. The above image will again be displayed briefly upon shutdown.

Basic Operation

Video Settings

Resolution

Automatic recording

The D2 will automatically power on and start recording once it begins

receiving a charge, such as when you start your car. There will be a

red dot blinking on the top left of the screen to indicate that it’s

currently recording.

Locking videos

While in Video Recording Mode, you can press the lock button to

manually lock the current video clip. This will ensure that Loop

Recording will not overwrite the clip when the memory card is full.

Locked videos can be found on the memory card under “\DCIMA\LOCA”.

Automatic shutdown

Once power is disconnected, the dash cam will shut down after 5 seconds.

These settings affect your video recordings. In Video Recording Mode,

press OK to stop recording, then press Menu once to open the Video

Menu.

Default setting: 1080FHD 1920*1080

Set the video recording resolution.

Approximate recording time

Memory Card Size 1080p Resolution 720p Resolution

16GB

32GB

2.5 hours

5 hours

4 hours

8 hours

Loop Recording

Exposure

Default setting: 2 Minutes

Video will be continually recorded in 1, 2, 3 or 5 minutes segments.

When the storage limit is reached on the memory card, new recordings

will automatically overwrite oldest recordings. Locked video files on the

memory card will remain protected, and will not be overwritten by

Loop Recording.

Default setting: +0.0

Manually adjust the camera’s exposure value to brighten or darken

recordings. Positive values brighten recordings, while negative

values darken them.

Motion Detection

Default setting: Off

When the machine is in the standby state, the camera will automatically

monitor whether there is any moving object in front. When the moving

object is detected, the machine will automatically record it.

Record Audio

Default setting: On

Allows you to enable or disable audio recording with your videos.

Note: Turning Loop Recording off would require you to manually clear

recordings from your memory card whenever storage is full, thus we

highly recommend keeping Loop Recording enabled.

Date Stamp

Default setting: On

Stamp the date and time to the bottom of your videos.

HDR (High Dynamic Range)

Default setting: Off

The camera automatically adjusts exposure settings to provide balanced

lighting and clear vide.

Gravity Sensing

Default setting: Medium

If a change in gravitational forces is detected, such as in the event of a

vehicular accident, the g-sensor will signal to the camera, and an

automatic file.

lock will be placed on the current video, preserving your most crucial

footage. Locked videos can be found on the memory card under

“\DCIMA\LOCA”.

Note: Locked video files will not be erased by Loop Recording,

they will remain on the memory card until they are manually deleted,

or when the card is formatted.

System Settings

Parking Monitor

Date/Time

Press twice to open the Setup Menu (in Video Recording Mode,

you must first stop recording, done by pressing OK).

Default setting: Off

When this function is enabled, the camera will automatically enter parking

mode whenever it is shut down. When parking mode is enabled and a

collision is detected, the dash cam will turn on and begin recording a 20

second video clip, which it will then lock to prevent overwriting.

Set the time and date on your device.

To enter the date/time:

Up/ Down – Change current value

OK – Move to next value

Menu– Confirm setting

Note: If the battery is fully discharged or removed from the device,

the time and date may be reset.

Auto Power Off

Default setting: Off

When enabled, this feature allows the device to shut down after a period of

time in which the camera isn’t recording.

Screen Saver

Default setting: Off

Specifies the duration for which the display will stay on after the device is

powered on. Having this setting disabled (default) will keep the display on

constantly, though you may manually toggle it with the button.

Beep Sound

Default setting: On

Enable or disable the device’s sound effects.

Language

Default setting: English

Set your preferred menu language.

Frequency

Default setting: 50Hz

Power supply specification used in your country or geographical region.

Format

Performing this operation will format the memory card, clearing it of all files.

Note: Locked videos will also be cleared, so ensure you have backed up

your important footage before formatting the card.

Default Setting

Performing this operation will reset all settings to their default values.

Version

Displays the current device firmware information.

Page is loading ...

Claoner Dash Cams for Cars Front and Rear FHD 1080P Dashcam, Dual Dash Cam User manual

Brand: Claoner

Model: Dash Cams for Cars Front and Rear FHD 1080P Dashcam, Dual Dash Cam

Category: Dashcam

Type: User manual

This manual is also suitable for

Dash Cam Car Camera Front and Rear FHD 1080P Dual Dash Cam Backup Car Camera

Download PDF

report

Claoner Dash Cams for Cars Front and Rear FHD 1080P Dashcam, Dual Dash Cam User manual

This manual is also suitable for

Claoner Dash Cams for Cars Front and Rear FHD 1080P Dashcam, Dual Dash Cam User manual

Other documents