Xanté Ilumina 502 Ilumina 427 User guide

RAM Upgrade

Step 1: With the power turned off, open the back panel over the

Control Unit. Loosen the two thumb screws on the panel and

rotate the panel on its hinges.



Step 2: Locate and replace the RAM memory modules.



Step 3: Close the back panel and tighten the thumb screws.



EEPROM Upgrade

Step 1: With the power turned off, open the back panel over the

Control Unit. Loosen the two thumb screws on the panel and

rotate the panel on its hinges.



Step 2: Replace the EEPROM on the Control Unit board. You will

need to use bent-nose pliers to properly remove the EEPROM.

Step 3: Install the new EEPROM making sure the small indentation

on the top is to the left side. This ensures proper polarity.

Close the back panel and tighten the thumb screws.

