Thank you for buying an Angelo Décor Fountain!
We ho
p
e
y
ou will find these instructions hel
p
ful in settin
g
u
p
y
our fountain. If
y
ou need mor
e
information to
p
ro
p
erl
y
care for
y
our fountain,
p
lease DO NOT return the unit to
p
lace of
p
urchase
.
Please visit our web site, www.an
g
elodecor.com, for assistance and warrant
y
information.
First un
p
ack carton carefull
y
, arran
g
in
g
p
arts safel
y
in
y
our workin
g
area.
Pump cord through standpipe. Adjust pump to desired setting. Connect tubing to the pump. Light cord through standpipe.
Make sure both power cords Insert rubber bung as shown. Set the light into the groove Set the cover plate into place
go through the groove at base. of cover plate
To use optional stabilizing system: Final installation should look as Adjust the direction of light
Insert pins and turn clockwise until tight. Slip leg over pin shown above. as desired.
until firm against back of fountain. Repeat for the other leg.
The final assembly should
look like this
Attach light cord to transformer. Be sure it is tight as shown.
Place transformer in secure area, preferably under cover.
While this unit is rated for outdoor use,it should not be full
y
submersed in the water.
Now sim
p
l
y
fill with clean water and
p
lu
g
into a
g
rounded GFCI outle
t
We recommend keeping bowl 3/4 full of water to avoid pump burnout.
Your fountain will work better, and last longer, when kept clean using a soft cloth and mild soap on a regular basis.
/
