Angelo Decor AD93236 Operating instructions

Thank you for buying an Angelo Décor Fountain!

We ho

ou will find these instructions hel

ful in settin

our fountain. If

ou need mor

information to

erl

care for

our fountain,

lease DO NOT return the unit to

lace of

urchase

Please visit our web site, www.an

elodecor.com, for assistance and warrant

information.

First un

ack carton carefull

, arran

arts safel

our workin

area.

Pump cord through standpipe. Adjust pump to desired setting. Connect tubing to the pump. Light cord through standpipe.

Make sure both power cords Insert rubber bung as shown. Set the light into the groove Set the cover plate into place

go through the groove at base. of cover plate

To use optional stabilizing system: Final installation should look as Adjust the direction of light

Insert pins and turn clockwise until tight. Slip leg over pin shown above. as desired.

until firm against back of fountain. Repeat for the other leg.

The final assembly should

look like this

Attach light cord to transformer. Be sure it is tight as shown.

Place transformer in secure area, preferably under cover.

While this unit is rated for outdoor use,it should not be full

submersed in the water.

Now sim

fill with clean water and

into a

rounded GFCI outle

We recommend keeping bowl 3/4 full of water to avoid pump burnout.

Your fountain will work better, and last longer, when kept clean using a soft cloth and mild soap on a regular basis.