Page 1 of 1
REV1.1
RGB/W signal repeater - Installation Instructions
Model RGBW-SR
Please read all instructions prior to installation and keep for future reference!
1. Ensure power to power supply is off before installing!
2. Use only with Class 2 power supply.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
www.luminii.com
+
-+
R
+
G
+
B
+
W
-
-
-
-
V
G
B
W
R
1
Remove covers on both sides of RGBW signal repeater by using
a small phillips screwdriver. Store covers and their fasteners until
repeater setup is complete and functioning properly and then
re-install them.
On the output side, connect the black positive wire of the Line
LED RGB to the “+” plus sign of the first color on the receiver
(the RED). Then connect the three remaining wires from RGB
LED strip to the negative slot of each respective color, like
shown in diagram. For the white light LED strip, connect red
wire to “+” sign and black wire to “-” of W slot.
Ensure power is off to power supply!
Also, ensure that the correct power supply
(voltage and wattage) is used to power the LED
strips connected to the repeater. Follow illustrated
wiring diagram. Use phillips head screwdriver to
open and close connection slots.
On the input side of the repeater, connect the black negative
wire from power supply to “-” minus sign on repeater. Then
connect the red positive wire from power supply to “+” plus
signs on repeater. Then connect colored wires from initial Line
LED RGB/W run in respective slots on RGB/W repeater like
shown below.
2
RGB/W signal
repeater
cover
cover
wires from power supply
initial Line LED
RGB /W run
This configuration can be replicated with additional RGB/W signal repeaters and adequate power supplies.
wires from
power supply
receiver/
decoder
INPUT OUTPUT
RGB/W
signal
repeater
A single strip of RGBW LED or two strips of RGB
LED and white light LED can be connected to the
repeaters and receivers.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Sunricher SR-3012 User manual
-
Fibaro FGRGBW-442 Operating instructions
-
Armacost Lighting RGB8KEY-RF Operating instructions
-
Armacost Lighting HHRGB14 Installation guide
-
Armacost Lighting HHRGB14 Installation guide
-
Essence WeR@Home Installation guide
-
Tripp Lite VGA over Cat5 Extenders/Splitters 9 Owner's manual
-
Tripp Lite VGA Over Cat5 Extenders and Extender/Splitters User manual
-
Crestron DGE-2 User guide
-
Tripp Lite B130-101-U Owner's manual
