2. Lindab
  3. Roof Transition Cardboard Roof

Lindab Roof Transition Cardboard Roof Operating instructions

  • Hello, I've reviewed the mounting instructions for the Lindab Roof transition. The document describes how to install it on a cardboard roof, including the use of sealant and specific hole size requirements. I'm ready to assist you with any questions you have.
  • What is the recommended flange thickness?
    What is the recommended sealant?
    What hole size is recommended for the roof transition?
1
2022-04-04
lindab | mounting instruction
We reserve the right to make changes without prior notice
Roof transition Cardboard Roof
© 2022-04-04 Lindab Ventilation. All forms of reproduction without written permission are forbidden. is the registered trademark of Lindab AB.
Lindab’s products, systems, product and product group designations are protected by intellectual property rights (IPR).
Flange thickness 0,9 mm. 10-15 mm. fugue
(performed by the roofer)
Roof transition
Flange on transition
Mounted in cold glue or e.g.
SabetoFIX PAP mounting glue
Upper carboard roof layer
Lower carboard roof layer
Roof material
Sealant from factory
Sealant e.g. SabetoFIX PAP
Hole size: Max 30 mm. larger
than the transition
/