2. BLOTZ
  3. B28-ST-134

BLOTZ B28-ST-134 Assembly Instructions

  • Hello! I have reviewed the instructions for assembling the BLOTZ Trapdoor model B28-ST-134. This document provides guidance on assembling the trapdoors from the provided pieces, including using glue, sandpaper, and a modeling knife. It also suggests painting techniques with wood stain and drybrushing. I'm ready to answer any questions you have about assembling or painting this model.
  • What kind of glue is recommended?
    What tools are required for assembly?
    Is it advised to paint before or after assembly?
28mm Trapdoors
B28-ST-134
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
You may find it easier to paint this model BEFORE assembly.
Apply a little wood stain to the base section and then paint the outside edge grey.
Spray the top section black and then drybrush it silver followed by brass / copper.
Each trapdoor is formed from the two pieces shown
above.
Glue them together as shown above.
The finished Trapdoors
/