2 Positioning microphone
Using the LXE
Single-Band Headset
NPart o. HX1501HEADSET
1 Adjusting headset to fit you
4 Replacing earpiece pads
Lower
audio cable
If earpiece pad
gets worn, pull it
off and replace it
with a new one
CAREFULLY bend headband
to fit you
To wear
earpiece on
other ear,
swivel boom
from one side
to the other
Cable with
quick-
disconnect
connector
Microphone
boom with
windscreen
Adjustable
headband
Client unit
163771-0001 Revis
ion A April 2010
Copyright © 2010 LXE, Inc. All Rights Reserved.
LXE is a registered trademark of LXE, Inc.
T
A
L
K
In front of
mouth
One finger-
width from
lips
Side of microphone
marked TALK
must face lips
2A 2B 2C
Adjust headband to
fit
3 Connecting to client unit
R
5 Wearing audio cable
Leave loop
so head
can turn
Wear
cable
inside
clothing
UNDER CLOTHING
(recommended)
OVER CLOTHING
(with cable in back)
OR
Do not wear cable
in front of body
Attach cables
securely to
clothing so they
let you work
without
restriction and
cannot get
tangled in
something.
!
6 Caring for the headset
Always
use wind-
screen
Do not
bend
boom too
much
Carry
headset by
headband,
not boom
OR
1
2
OR
4 hrs
7 In harsh environments
Every four hours, or when windscreen gets moist or
frozen, replace windscreen
If the microphone stops working, it might be too
wet. Try removing the windscreen, shaking
moisture out of the microphone, and replacing the
windscreen with a dry one
1
2
Do not
squeeze wet
windscreen
while on
boom
3
Leave loop so head
can turn
Clip headset cable
to clothing
Clip lower audio
cable to clothing
Wear cable
across back
Do not twist
microphone too
much
Clip to
clothing
-
1
-
2
