2 Positioning microphone
T
A
L
K
TALK
Side of microphone
marked
must face lips
2C
In front
of mouth
2A 2B
One finger-
width from lips
CAREFULLY bend headband to fit you
3 Connecting to client unit
Copyright © 2010 LXE, Inc. All Rights Reserved.
LXE is a registered trademark of LXE, Inc.
16377
3-0001 Rev. A April 2010
If earpiece pad gets worn,
pull it off and replace it
with a new one
If strap gets worn, pull
it off and replace it
with a new one
4 Replacing earpads and strap
Using the LXE
Behind-the-Neck Headset
Part No. HX3601HEADSET
1 Adjusting to fit you
Adjustable
strap
Microphone
boom with
windscreen
Cable with
quick-disconnect
connector
Clothing
clip
Earpads with
replaceable pads
Dual-Ear Wireframe
R
5 Wearing audio cable
Leave loop
so head
can turn
Wear cable
inside
clothing
UNDER CLOTHING
(recommended)
OVER CLOTHING
(with cable in back)
OR
Clip lower audio
cable to clothing
Wear cable
across back
Clip to
clothing
Do not twist
microphone
too much
OR
OR
4 hrs
7 In freezer environments
Every four hours, or when windscreen gets moist or
frozen, replace windscreen
If the microphone stops working, it might be too
wet. Try removing the windscreen, shaking
moisture out of the microphone, and replacing the
windscreen with a dry one
Do not squeeze
wet windscreen
while on boom
Do not
wear cable
in front
of body
Attach cables securely to clothing so they let you work
without restriction and cannot get tangled in something.
!
!
1
2
3
2
1
Clip headset cable
to clothing
Leave loop so head
can turn
bend
boom too
much
Carry
headset by
headband,
not boom
Always use
windscreen
6 Caring for the headset
Do not
Do not
snap them
When
disconnecting,
pull the
connectors
apart
-
1
-
2
